no there is not one
1. Make sure your trip odometer is on Trip A. 2. With the car turned off, press and hold the "Reset" button for the trip odo. 3. Foot off the brake, press the start button twice while holding the reset button and wait for it to reset.
1. Make sure the odometer is set to total miles and not to trip. 2. With the ignition off (this car has a start button and not a key switch) hold the trip reset button down. 3. Tap the start button one time quickly (don't start the car) after the information center lights tap the start button one more time quickly, again don't start the car. 4. The dash lights come on and a series of dashes appear where the mileage was. When these dashes count down and disappear the maintenance reminder is reset.
Check inside your glove compartment and make sure you have the trunk switch set to open with the button. This is a safety feature for valet parking.
Key in position 2, scroll to service due screen then hold down reset button on the cluster for a few seconds, then it will ask if you wish to reset button. Push button on the cluster again to reset. MAKE SURE DOOR IS SHUT
The fuel pump reset switch is in the trunk, on the left side, behind the trunk liner. (There is a hole that you can access it from.) Tips: - If you don't smell gas or see any gas leaking, push the reset button down that has popped up on the top of the switch. - Turn your ignition key to the RUN position for a few seconds, then turn your ignition key to the OFF position. - Check if it is leaking gas, or smells like it just to make sure, and if it isn't leaking or smelling like gas, go ahead and start the engine.
To locate and use the hot tub heater reset button, first, look for a control panel near the hot tub. The reset button is usually a small red button on the control panel. Press and hold the reset button for a few seconds to reset the heater. Make sure to follow the manufacturer's instructions for your specific hot tub model.
In order to reset a tripped fuel cut off switch you depress the red button located on the top of the switch. To locate the switch depends entirely on the year and make. Most likely its in the trunk area or in the right front kickpanel area.
Impossible to answer. Several islands on Poptropica have puzzles, and most have reset buttons.
There are 4 button functions on the c9 Champion watch A (light), B (mode), C (start), and D (reset). To change the time, you need to push the mode button 3 times. This will cause the seconds place value begin to blink. By pressing the reset button you can move to hour, minutes, and seconds. You can increase the time by one digit by pushing the start button once or hold it in to make the numbers move faster. Once you have entered the correct time, hit the mode button to allow your watch to start keeping time.
First , the switch is located in the trunk on the drivers side , either on a bracket beside the left side trunk hinge or it's behind the trunk liner - if you don't see any gas leaking or smell gas push the reset button down that has popped up on the top of the switch - turn your ignition key to the RUN position for a few seconds and then turn your ignition key to the OFF position - make another check for any gas leaking or the smell of gas , if none , go ahead and start the engine
First , the switch is located in the trunk , on the drivers side , behind the trunk liner ( there is an access ) If you don't see any gas leaking or smell gas push the reset button down that has popped up on top of the switch Turn your ignition key to the RUN position for a few seconds and then turn your ignition key to the OFF position Make another check for any gas leaking or the smell of gas , if none , go ahead and start the engine
Make sure odometer (ODO) is slelected (not trip odometer). Hold in odometer "reset" botton. Turn Igniotion to ON but do not start engine. Light will flash and go off. Turn Ignition OFF. Release "reset" button.