answersLogoWhite

0

The reverse light sensor is located at the side of the gearbox and has two wires running to it. To test run a wire across the two and if it lights up that is your problem.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you remove a change a brake light switch on a Citreon Xsara?

To change the brake light switch on a Citroën Xsara, first disconnect the negative battery terminal for safety. Then, locate the brake light switch, which is typically found near the brake pedal assembly. Remove the electrical connector from the switch, then unscrew and take out the old switch. Install the new switch by reversing the process and reconnecting the electrical connector before reattaching the battery.


Where is the reversing light switch on a Toyota avensis?

How do I get to the reversing light switch on a Toyota avensis 2005


How do you change reversing light switch on citroen Picasso?

To change the reversing light switch on a Citroën Picasso, first, ensure the vehicle is safely parked and the ignition is off. Locate the reversing light switch, usually found on the gearbox or near the transmission. Disconnect the electrical connector and remove the old switch by unscrewing it or twisting it out, depending on the model. Install the new switch by reversing the removal process, reconnect the electrical connector, and test the lights to ensure proper functionality.


How do you fix brake light switch in citreon xsara 1.4 2001 model?

To fix the brake light switch on a Citroën Xsara 1.4 (2001 model), first disconnect the battery to ensure safety. Locate the brake light switch, typically found near the brake pedal arm. Remove the old switch by disconnecting its wiring harness and unscrewing it from its mount. Install the new switch by reversing the process, ensuring it is properly aligned and secured, then reconnect the battery and test the brake lights.


Where is the reverse light switch located on a citroen c2 vtr?

Where is the reverse light switch on a CiTREON C2


How do you replace reversing light switch on a Land Rover discovery?

To replace the reversing light switch on a Land Rover Discovery, first, disconnect the vehicle's battery to ensure safety. Locate the switch, typically found on the transmission or gearbox, and remove any necessary covers or panels. Disconnect the wiring harness from the old switch, unscrew it from its mounting, and then install the new switch by reversing the process. Finally, reconnect the battery and test the lights to ensure proper functionality.


Where is the Reversing light switch for Honda CR-V?

The reversing light switch for a Honda CR-V is located at the front lower part of the transmission. It is almost at the bottom of the transmission, but up front.


How can I use the power to switch on the light?

To use the power to switch on the light, locate the light switch and flip it to the "on" position.


Where is the reversing light switch on a Peugeot 406?

the switch is located on top of the gearbox,under the airfilterbox


How do you locate the reversing switch on a 2005 vw polo?

To locate the reversing switch on a 2005 VW Polo, you'll need to look near the transmission. The switch is typically mounted on the transmission case, often on the side or rear, and is connected to the reverse light circuit. You may need to raise the vehicle for better access, and it can be identified by its electrical connector. Always ensure the engine is off and take safety precautions when working underneath the vehicle.


Where is reversing light switch on Nissan primera?

hen you put it in reverse


How do you change brake light switch on a Skoda fabia?

To change the brake light switch on a Skoda Fabia, first, disconnect the vehicle's battery to ensure safety. Locate the brake light switch, which is typically situated above the brake pedal. Remove the electrical connector from the switch and unbolt or unscrew the switch from its mounting. Install the new switch by reversing the process, ensuring it is securely fastened, and reconnect the battery to test the lights.