answersLogoWhite

0

The intercooler hoses deliver air from the turbocharger outlet to the intercooler inlet and from the intercooler outlet to the engine intake manifold. When air is compressed in the turbocharger, it gets heated. The intercooler cools the air coming out of the turbocharger before it goes into the engine. Cooling the intake air helps prevent detonation (engine knocking) and lets the engine use a little bit higher compression ratio.

User Avatar

Wiki User

16y ago

What else can I help you with?

Related Questions

What does the lower raditor hose connect to on a 1990 Volvo 240?

Lower hose goes between rad and water pump !! KM


What is the purpose of Volvo turbo cars?

The purpose of turbo Volvo cars are to allow faster altered driving. They are typically more expensive than regular cars, since they are modified cars.


How do you replace a radiator hose on a 1998 Volvo v70?

To replace a radiator hose on a 1998 Volvo V70, first ensure the engine is cool and disconnect the negative battery terminal. Drain the coolant from the radiator by opening the drain valve or removing the lower radiator hose. Loosen the clamps on the old hose using a screwdriver or pliers, then remove the hose from the radiator and engine. Install the new hose by sliding it onto the fittings, securing it with clamps, and refill the cooling system with coolant before checking for leaks.


How do you replace heater hose on Volvo 2000 V70?

To replace the heater hose on a 2000 Volvo V70, first ensure the engine is cool and disconnect the negative battery cable. Locate the heater hose running from the engine to the heater core, then use pliers to loosen the hose clamps and carefully remove the old hose. Install the new hose by securing it with the clamps, making sure it's properly seated, and finally reconnect the battery cable. Check for leaks after running the engine and ensure everything is functioning correctly.


How do you remove the fuel tank on a 1994 Volvo 940?

fuel intake hose is bad needs to be replaced


Where is the coolant temperature sensor located on a 2003 volvo s40?

Next to the thermostat. you will see it when you remove the hose


89 Volvo 740 turbo. what is the dual rubber hose that connects the vapor canister to the throttle body called?

The dual rubber hose that connects the vapor canister to the throttle body in an '89 Volvo 740 Turbo is commonly referred to as the "evaporative emissions control hose" or simply the "vapor hose." This hose is part of the vehicle's evaporative emissions system, which helps control fuel vapors and reduce emissions. If you're replacing it, ensure you get the correct size and specifications for your model.


What is the purpose of a hose bib washer and how often should it be replaced to maintain optimal functionality?

The purpose of a hose bib washer is to create a watertight seal between the hose bib and the hose, preventing leaks. To maintain optimal functionality, the hose bib washer should be replaced annually or whenever signs of wear or deterioration are noticed.


How do you fix Volvo 850 rough idle?

A leaky mass airflow sensor or it can be a leak in the air intake hose.


Where is coolant drain plug on 1999 Volvo vn truck?

Should be on the low side of the lower radiator hose.


What is the purpose of the packing nut on a hose bib?

The purpose of the packing nut on a hose bib is to create a watertight seal and prevent leaks by compressing a packing material around the stem of the bib.


What is the purpose of the garden hose o ring and how does it help in maintaining a leak-proof connection between the hose and the water source?

The purpose of the garden hose O-ring is to create a tight seal between the hose and the water source, preventing leaks. It is a small rubber ring that fits inside the hose connector, ensuring a secure and leak-proof connection.