0
Here is what the shop manual says.
1. Drop the head liner.
2. Disconnect teleflex cable end from sunroof.
3. Press sunroof button to "open" to disengage cable from motor gearbox.
4. Remove cover in trunk on LH side and disconnect motor wires.
5. Disconnect teleflex tube.
6. Remove unit.
If the cable is frozen you have to disassemble the gearbox on the motor assembly.
If the motor is dead you can manually open and close the roof from the motor assembly.
As a side note you may be able to disconnect the teleflex tube at the motor and just run the roof open to disengage the cable from the gearbox. This would keep you from having to remove the head liner. I have not tried this but I would try is first
Hope this helps.
What else can I help you with?
How do you remove sunroof motor from an 1983 300 SD?
Remove the sunroof headliner. Pull the flex cable forward until out of the motor. Remove the left(driver’s side) plastic fender panel in the trunk. Disconnect the wires. Take out the mounting screws. Gently separate the flex cable’s tube from the motor/gear assembly.
I have a 1983 Mercedes Benz 300sd turbo diesel There is a rainwater leak that comes in either from the sunroof the windshield or some other opening How to I stop the leak and what should I use?
The leak may be from clogged Sunroof drains. Others have said that you can use compressed air to clear the lines to have them drain properly.
Where do you put the power steering fluid in a 1983 Mercedes Benz 300D Turbo?
in the power steering pump, on drivers side out near front of motor.
When was Mercedes Homes created?
Mercedes Homes was created in 1983.
When was Mercedes Nicoll born?
Mercedes Nicoll was born in 1983.
How do you remove hood hinges on a 1983 Mercedes 300SD?
UNLOCK THE HOOD AT THE HINGES AND FLIP THE HOOD ALL THE WAY UP, THEN THE SPRINGS WILL COME RIGHT OUT
Will a 1978 300d Mercedes transmission work in 1983 300sd Mercedes?
yes
How do you replace heater motor on 1983 vw rabbit gti?
To replace the heater motor on a 1983 VW Rabbit GTI, first, disconnect the battery to prevent electrical shorts. Remove the dashboard or the panel covering the heater assembly, which may involve unscrewing various fasteners. Then, disconnect the wiring harness from the heater motor and remove the mounting screws to take out the old motor. Finally, install the new motor, reconnect the wiring, and reassemble the dashboard or panel.
How do you replace trunk lid springs on a 1983 Mercedes 380sl?
How do you replace trunk lid springs on a 107 body 1983 mercedes 380sl?
What Mercedes factory radios will fit in your 1983 Mercedes 380sec?
Mercedes came stock with the Becker radio and tape player.
Which taillight bulb is specified for a 1983 Mercedes E320?
A 1983 E320 does not exist, however, a regular 21W for brake light and 5W for taillight should do for just about any Mercedes Benx from 1983
What size motor is in a 1983 Mercedes 380 sl?
Sort of like, name three members of the band Emerson Lake & Palmer. The 380 has a 3.8 liter V8, about 235 cu inch.
