IDK who would know that only nerds not popular people like me!
crank shaft sensor take off and clean it is on the bell housing ofthe gear box
They just glue it on at the factory.So just pull hard and twist it at the same time, and it will come off quite easily.
faulty clutch. shudder while pulling away , then shudder goes away at higher speed More likely to be a duff gearbox mounting, common fault on the scenic.
If its more like a judder, clutch, could be oil or damaged plate.
hi mr that i have renulat secnico 2000 which type of oil for gear box if i need to change it please can you advice as regard Eiad
Time for a rebuild.
To turn on traction control in a Renault Scenic, locate the traction control button, usually found near the gear lever or on the dashboard. Press the button, which may be labeled with a car icon and squiggly lines. The traction control system indicator on the dashboard should illuminate to confirm it's activated. If it does not turn on, refer to the vehicle's manual for troubleshooting steps.
I cant put my corsa into gear it is going from side to side and losing power
Had a similar message on safrane v6 auto..ignored it it cost me nearly £2000 in rebuild costs get it checked out!
To change the reverse light on a Renault Scenic, first ensure the vehicle is turned off and the keys are removed. Open the rear hatch and locate the light cluster; you may need to remove a cover or screws to access it. Twist the bulb holder counterclockwise to remove it, replace the old bulb with a new one, and then reassemble the light cluster. Finally, test the new bulb by engaging the reverse gear while someone checks the lights.
its a fail safe mode. possibly the multifunction sensor is not working well or is damp. try drying it up and use the electronic tool to reset it. there is a temp solution to override it, via a button located near the gear lever. plse check with the mechanic. other reasons might be the gear linkage or the gearbox.