answersLogoWhite

0

Turn the key to position 2, press R button (the buttonto reset petrol gauge etc..) release R button, turn key off and press the same button, whilst holding it turn key to position 2 again and hold for ten seconds

service indicator should say theres 10,000 miles to next service

may take a couple of tries, good luck Shayan

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you reset service indicator Mercedes ml 270 cdi?

The service indicator light, in your Mercedes ML 270, can be reset by holding in the engine oil life button. The engine oil life will go to 100 percent. The service indicator light should go off.


How do you reset the service indicator on a Mercedes ml 270 cdi 2002?

Itshould be listed in your owners manual under maintainence


What does service e mean on a Mercedes E270 cdi?

merc e 270 cdi service


Mercedes w211 service interval?

i have changed oil and oil filter in mercedes e 270 cdi w211, but still srvice B on the screen. What is can be?


What does the ML mean on the Mercedes ML 270?

Mansie long


How much the new key Mercedes ml320 cost?

A new key for a ML 270 cost $370AUS


Where is the rail pressure regulator in Mercedes ML 270 CDI?

In the Mercedes ML 270 CDI, the rail pressure regulator is typically located on the fuel rail, which is situated on the engine's cylinder head. It is responsible for maintaining the correct fuel pressure within the common rail system. Accessing it may require removing engine covers or other components for better visibility and reach. Always refer to the vehicle's service manual for specific instructions and locations.


Why is your seat heater not working on your Mercedes ml 270 CDI but the light keep flashing for a while and then stops?

If the seat heater in your Mercedes ML 270 CDI is not working and the indicator light flashes before stopping, it could indicate a malfunction in the seat heater system. Common issues include a faulty heating element, a problem with the seat control module, or a blown fuse. The flashing light typically suggests that the system has detected an error and is unable to activate the heater. It’s advisable to have the vehicle inspected by a qualified technician to diagnose and resolve the issue.


When do you change the cam belt on a Mercedes clk 270 cdi?

The best time is before it snaps.The worst time is after it has snapped.


What are the torque specifications on the cylinder head bolts of a Mercedes Benz ML 270 CDI?

The torque specifications for the cylinder head bolts on a Mercedes Benz ML 270 CDI typically require an initial torque of 30 Nm (22 lb-ft), followed by a further tightening to 90 Nm (66 lb-ft), and then an additional angle turn of 90 degrees. It's essential to follow the proper sequence and procedure outlined in the service manual to ensure even pressure across the cylinder head. Always refer to the manufacturer's specifications or service manual for the most accurate information.


Does all Mercedes ml 270 have an in-tank pump?

Yes, all Mercedes ML 270 models are equipped with an in-tank fuel pump. This design allows for efficient fuel delivery and helps maintain consistent fuel pressure. The in-tank pump is a common feature in modern vehicles, including the ML series, to enhance performance and reliability.


Oil capacity of 2003 Mercedes clk 270?

hi ive been told that mine is 7 lt for a total oil and filter change