answersLogoWhite

0

Mine went into transmission failsafe mode, and takes off very very slow

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

Where is the camshaft position sensor located on a 1998 BMW 740iL?

Near bottom of trans bell housing right side


Knock sensor location on a BMW 740il?

The knock sensor on a BMW 740Il is located on the top of the engine. It is mounted under the intake manifold.


Where is the knock sensor on a 1998 BMW 740il?

There are four under the intake manifold


Locationof IAT sensor on 2001 BMW 740IL?

intake air temp sensor is located on the air filter box lid.


Where is the bank 1 oxygen sensor for BMW 740iL?

hi i have 2001 bmw 740il it has code po171 ,174 system too line i chenge entek gasket spark plag valve cover gasket pcv oxeygen sensor but again i have same problem what.s my problem ?


How do you reset tilt sensor on 1997 BMW 740IL?

You need a code reader or have a shop that has one plug into diagnostic port & can reset it for you.


How do you change a flat on a BMW 740iL?

How to change flat on a 740il


Where are the cat converters on a 1998 bmw 740il?

Almost directly under the ashtray if you where looking under your car, it has an o2 sensor in front and back of it on both sides


How do you replace 1997 BMW 740il starter?

How do you replace starter in 1997 BMW 740il??


How do you install wiper motor for BMW 740il?

wiper motor not working on my 1997 BMW 740IL


Where is the crank shaft sensor on a 1998 BMW 740il?

The crank shaft sensor on a 1998 BMW 74Oil is located down near the crank on the front of a motor. It is super easy to replace but sometimes reaching the harness wire is a little bit difficult.


1993 BMW 740il check automatic transmission fluid?

how to put transmission fluid in a 740il BMW 1993