0
What else can I help you with?
What is the primary stage of a tire?
The primary stage of a tire are the inner liner, body plies and side walls. If these 3 components were not in the tire the tire would not be able to sustain high pressures of air.
What should the tire pressure be for a 2000 Malibu?
tire pressures can be found 1)on the tire sidewall,2)in your owners manual 3)and sometimes either in the glove box or on the VIN label inside the driversside door panel.
What date while is the Renault Clio launched?
Clio Mk 1 - 1990-1998 Clio Mk 2 - 1998-2006 Clio Mk 3 - 2006-present Clio Mk 4 - due 2012
What are the tire pressures for a vauxhall vectra sri 150 1.9?
up to 3 persons - 33 all round fully loaded - 35 front 42 rear
Where do you find the gear ratio of the rear differential on an 85 silverado?
You make a mark on the tire and rotate the tire one full round while counting the number of turns of the drive shaft. If the shaft turns 3 times while the tire turns once the ratio is 3:1.
How far is Clio MI from Cedar Point?
Clio, MI is 187 miles from Cedar Point. That is about a 3 hour drive.
What is the correct tire pressure for a 2009 sportster xl883?
There should be a label on the inside of the drivers door that will give you one option for tire pressures for factory installed tires. If you have replaced the tires and they are not exactly the same as the ones you removed the sidewall of the new tire will give you a range that is acceptable. For longer tire life try and stay within 2-3 lbs of the max pressure.
What is correct tire pressure for BMW 3 series tire size 255 35 zr18?
All correct tire pressures can be found on two locations, Inside the drivers door on the B pillar, open the door and look where their is labels one of them will have correct tire size for the car and also pressure recomended, another location is on the inside of the Gas door. I would suggest 34 on all.
Tire pressures for vauxhall vectra 3.2 v6 215 50 17 w91?
40 PSI front and rear up to 3 passengers. Yes, 40 PSI. I had to read it twice in the manual.
How do you reset the tire pressure monitoring system on a buick rendezvous?
# Set all tire pressures to the recommended kPa/psi. # Turn ON the ignition, with the engine OFF. # Press the MODE button until LOW TIRE PRESSURE HOLD SET TO RESET is displayed. # Press and hold the SET button until a chime sounds and TIRE PRESSURE RESET is displayed and a chime sounds 3 times. # release the SET button and TIRE PRESSURE NORMAL is displayed.
How do you change a fog light on a Renault Clio mark 3?
To change a fog light on a Renault Clio Mark 3, first, ensure the vehicle is turned off and the keys are removed. Access the fog light by either removing the protective cover or the entire fog light assembly, which may require unscrewing some bolts. Disconnect the old bulb from the wiring harness, replace it with a new one, and reassemble everything securely. Finally, test the fog light to ensure it’s functioning properly.
How do you remove Renault clio mark 3 high level brake light?
To remove the high-level brake light on a Renault Clio Mark 3, start by opening the tailgate and locating the two plastic covers on either side of the light. Carefully pry off these covers using a flathead screwdriver or a trim tool to expose the mounting screws. Unscrew the screws holding the brake light in place, then gently pull the light assembly away from the tailgate. Disconnect the wiring harness to fully remove the brake light.
