answersLogoWhite

0

If you have a union in the suction piping as many well systems do it may be the culprit. some times tightening the union will fix the problem.
Another place air can enter is through the pump seal,if it is worn it may allow air to be pulled into the pump when it is running. replacing the seal can sometimes fix the problem. If you are losing the prime on your well system the problem is between the check valve and the well,if not the problem is between the check valve and the pump.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

What causes a Chevy 1 ton pickup to blows valve gaskets?

check your PCV Valve


Why is your turbo building boost but breaking up?

Need to check if blow-by valve is working correctly.


What does WP mean on a check valve?

WP on a check valve typically stands for "Working Pressure," indicating the maximum pressure at which the valve can operate safely. This specification is crucial for ensuring the valve's reliability and performance in a fluid system. It's important to select a check valve with a WP rating that meets or exceeds the system's operating pressure to prevent failures.


What causes a rebuilt motor not to start?

Check the valve timing and the ignition timing. If both are good then check the compression in all the cylinders.


What should I check the heater on my 1992 Pontiac trans sport just stopped working?

Thermostat possibly stuck open or heater control valve broken. Now if you mean the blower motor has stopped working, check the fuse, blower motor itself, or the blower motor resistor pack.


How tight should bolts be so oil wont leak from valve cover?

Check the specs for the vehicle you are working on (You can find them on the net if you do not have the manual) and the torque requirements will be there. Do not over torque the bolts as removing a broken valve cover bolt is a pain. Good luck.


What causes a misfire on cylinder 3?

You did not say what you are working on. but you can check the plugs, wires, coil, and maybe the fuel injector low engine compresson, broken valve spring.vaccum leak... dist cap. Realey need more info.


What should I do if my hot water faucet is not working properly?

If your hot water faucet is not working properly, you should first check if the hot water supply valve is open. If it is open and the issue persists, you may need to check for any blockages in the faucet or the hot water pipe. If you are unable to fix the problem yourself, it is recommended to contact a professional plumber for assistance.


What is the recirculate position on a pool filter valve for?

intex sand filter is not working on filter only working on recirculate position.....what should we do


What causes rough idleing for a 2000 ford explore?

check the idle control valve not that hard to replace and inexpensive


What causes rear air conditioner to blast hot air while front unit is working perfectly well?

Check the temperature control valve. You're probably allowing hot engine coolant through the rear heater coil.


How often a PCV valve should be replaced in a 2000nissan altima?

replace only when u get a check engine light. the valve is good for the life of the motor(should be)