answersLogoWhite

0

In 1990-1994 XJ6 the VCM Code 44 is the code for the O2 sensor, either rich or lean exhaust has been detected and is causing the code to trigger. It could indicate a bad O2 sensor.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

What does a Fuel Fail 47 code mean on a 1993 Jaguar XJ6?

Fuel Fail 47 Idle speed contol valve - coil 2: Open or short circuit.


What does fuel fail 17 mean on a Jaguar?

It is the code for the TPS Throttle position sensor


1994 jaguar xj6 vcw code 48 fuel fail?

This means Idle speed control motor (ISC) or valve


What does Fuel Fail 46 VCM code mean on a 1993 Jaguar XJ6?

Idle speed control valve coil 1 fault. Off voltage not less than 0.85 volts or on voltage not exceeding 12.25 volts.


What if your jaguar xj6 vcm says fuel fail 47?

Fuel Fail 37 is either a fault with the EGR Valve or its Solenoid


1991 Jaguar XJ6 VCM fault code 89 fuel fail what does it mean?

Evaporative canister purge control valve circuit fault


Where is the fuel pump located on a 1993 jaguar xjs?

The fuel pump is in the fuel tank.


Fuel fail 29 on 1991 xj6 jaguar?

low battery. had battery tested load type. faild replaced battery fix code 29 thank you


What does fuel fail 22 mean on a 1990 jaguar xj6?

Ignition Amplifier Failure


1991 Jaguar XJ6 VCM fault code 69 fuel fail what does it mean?

I own a 91' XJ6 also and i believe when that code comes up it is as simple as your gas cap not being on all the way


What does fail fuel 66 mean in your 1993 xj6?

code42


What is fault code FF17 on a jaguar xjs 1993?

Fault code FF17 on a 1993 Jaguar XJS typically indicates an issue with the engine management system, specifically related to the fuel mixture or oxygen sensor readings. This code often points to a problem with the air-fuel ratio, which can affect engine performance and emissions. It’s advisable to check the oxygen sensors and the fuel injection system to diagnose and resolve the issue. Always refer to the vehicle’s service manual for specific troubleshooting steps.