answersLogoWhite

0

The throttle potentiometer is not functioning properly. Unlike most parts this one is easy to get to, but unless you're a mechanic or know how to use a volt meter I would take it in for this problem.

User Avatar

Wiki User

18y ago

What else can I help you with?

Related Questions

1998 jaguar vandenplas fail safe engine mode what does this mean?

The "fail-safe engine mode" in a 1998 Jaguar Vanden Plas indicates that the vehicle's engine management system has detected a problem and has triggered a protective measure to prevent further damage. In this mode, the engine may run at reduced power or performance levels to allow the driver to safely reach a service location. Common causes for this activation include issues with sensors, fuel delivery, or ignition systems. It's important to have the vehicle diagnosed by a professional to identify and resolve the underlying issue.


How do you replace a headlight on a 1988 Jaguar Vanden Plas XJs 6 cylinder 4 door car?

Inside the the front wheel well. Just below the top of the front tire. You will find a a removeable plastic panel. That is held in place by a few pastic clips. Remove this cover and remove the bulb from the head light. By twisting the plastic ring about 60degrees or so to the left. Just in case you are not aware of the fact. Never touch the bulb with your bare hands. The oil from your hands will cause the bulb to fail. If you recently used the headlights. Let them cool off for at least 1/2 hour or so before you atempt to change them. You can receive serious burns from the bulbs if you dont. If you have the dual sealed beams like my Vanden Plas had, you have to unscrew the retainer screws from the front side and pull the bulb out the front. Pull the clip off the back and plug in new bulb, push bulb back in and retighten the retainer. If you have the square lights I would swap them out! I put the twin sealed beams from my Vanden Plas on my 90 Soveriegn after the Vanden Plas reached parts-car status. A little bit of work, but it looks so much classier!


Where is the problem with VCM indicating Fail 44 of jaguar?

what means fail 44 of vcm of jaguar


How to reset jaguar fail safe?

jaguar sovereign engine failsafe mode reset


What does Fail Safe Engine Mode mean on 2000 Jaguar XK8?

what does fail safe engine mode mean on a 2000 jaguar s type? how to fix this problem?handle


What does fail 17 and fuel 17 on your 1992 jaguar?

In a 1992 Jaguar, "Fail 17" typically indicates a problem with the engine management system, often related to the fuel system or sensors. "Fuel 17" may refer to a specific fault code linked to fuel delivery or pressure issues. It's essential to consult the vehicle's service manual or a professional technician to diagnose and address these codes accurately. Proper diagnostics can help ensure optimal performance and reliability.


What if your jaguar xj6 vcm says fuel fail 47?

Fuel Fail 37 is either a fault with the EGR Valve or its Solenoid


What does fuel fail 22 mean on a 1990 jaguar xj6?

Ignition Amplifier Failure


What does fuel fail 17 mean on a Jaguar?

It is the code for the TPS Throttle position sensor


What does fuel fail 69 mean on vcm of 1993 jaguar xj-6 vanden pla?

The Haynes manual says an error code 69 is a neutral safety switch circuit / Engine cranks in drive (adjust or replace switch). Note: the Shift cable for the Automatic Transmission stretches over time and should be adjust, if too long cable will need to be replaced.


What does a Fuel Fail 47 code mean on a 1993 Jaguar XJ6?

Fuel Fail 47 Idle speed contol valve - coil 2: Open or short circuit.


What does 'PAO Fail' mean on the VCM of a 1989 Jaguar XJ6?

it means Pad NOT Pao YOUR BRAKE PADS ARE LOW.