0
What else can I help you with?
How do you install wheel bearing for 2000 Mazda protege?
the haynes book says take it to a mechanic
How do I replace a Steering wheel on a 1999 Chevy Cheyenne 2500?
Get a repair book at the library. And you need a wheel puller, a tool.
What is the blue book value of a 2001 Chevrolet s10 4 wheel drive?
www.kbb.com
What is the blue book value of a 1984 Ford Bronco II 4 wheel drive?
Yes
What characters are featured in the Wheel of Time book series?
There are tons of characters featured in the Wheel of Time book series and these are just a few of them. Black Ajah, Blue Ajah, Brown Ajah, Gray Ajah, and there are many more.
What are the wheel bearing torque specs on 1980 Monte Carlo?
my book says 15 lbs then back off just enough to line up cotter pin
Can you do a front right wheel bearing on 91 topaz myself without any special tools?
there are no front wheel bearings in front wheel drive cars To correctly answer your question yes, there are front wheel bearings--in fact I am going to have to have mine replaced. In the Mercury Topaz book from Haynes they do not reccommend that you do them yourself. I'm thinking that a special press is used for it. Puglet
Blue book value on 1987 Ford Ranger 4-wheel drive?
a penny, ford rangers arent worth crap
Should you replace a blown engine on a 1993 Trooper or junk it?
compare the blue book value to the cost of replacement. is it worth it???
How do you remove of 1996 Honda Accord front rotor?
Remove wheel. Take off outer driveshaft nut. Remove lower ball joint pinch bolt & separate ball joint from spindle. Pull rotor & spindle out & away to pull driveshaft outer splined end out of rotor center hub. Look on the back of the spindle for the 4 bolts that hold in the wheel bearing. Use a 12 point socket to remove the 4 bolts and remove wheel bearing from spindle (out towards the wheel stud side). Probably will have to use a air chisel to get it out. Once it's out undo the 4 bolts on the outer (wheel stud side) of the rotor and remove the rotor from the hub. Clean & lube the hole where the bearing was in the spindle & the inner face of the hub. MAKE SURE IT'S CLEAN otherwise you may get a pulsation on braking if theres a piece of rust or dirt between the rotor center & the hub face. Reverse procedure to install. If the rear bolts don't come out then you will have to use a slide hammer to separate the bearing to replace the rotor and there is a very good chance you will need to replace the wheel bearing after you're done (noisy on road test). Not the job to do at home, usually an easy 2-3 hours per side if things go bad (book time is 2.2 hrs per side). Use good quality rotors as you don't want to have to do it again because a cheap rotor gave you a pulsation.
Is there a book or chapter of Isaac?
There is no book in the Bible bearing his name. His story can be read in Genesis 17.
When is a blue school book not a blue school book?
When it's red.
