0
For a Citroën Relay, the recommended engine oil generally depends on the specific engine type and model year. However, a common specification is 5W-30 fully synthetic oil, which provides good protection and efficiency. Always consult the owner’s manual or check the manufacturer’s guidelines for the exact oil type and specifications for your particular model.
What else can I help you with?
Where do you put the gearbox oil in a citroen xsara Picasso?
Gearbox and engine oil all one.
How do you put gear oil into Citroen relay van?
To add gear oil to a Citroen Relay van, first, locate the gear oil filler plug, which is typically found on the side of the transmission. Use a wrench to remove the plug. Then, using a funnel or a pump, pour the appropriate type of gear oil into the filler hole until it reaches the correct level, which is usually just below the filler neck. Finally, replace the filler plug securely.
How do you increase power in a Citroen Saxo?
put a vtr or vts engine in it
Can anyone please tell you how to check the gearbox oil level on a citroen relay 2.5d 2001 model?
These gearboxes fill with water. Drain it and you will see.I did. A breakers yard put me on to it. Design fault - happens to all of them!!
Do you put crankcase oil directly to the engine as you do with engine oil?
Crankcase oil is engine oil , so yes
How do you remove engine from citroen Picasso?
take out bolts & wires lift it up & put it on floor
How much engine oil do you put in ktm 85?
How much engine oil do you put in a ktm 85
What if you put transmission fluid in the engine instead of the transmission by mistake?
You should drain the oil in the engine. Put engine oil back in the engine because the transmission oil is not made for engines and will hurt the moving parts of the engine if left in.
Where do you put the oil?
in the engine Einstein
Where do you put the engine oil in on a citroen saxo vtr?
To add engine oil to a Citroën Saxo VTR, open the hood and locate the oil filler cap, which is usually marked with an oil can symbol. Remove the cap and use a funnel to pour in the appropriate type and amount of oil as specified in the owner's manual. After adding oil, replace the cap securely and check the dipstick to ensure the oil level is within the recommended range. Always check for leaks and ensure the engine is off and cool before performing this task.
Pictures of where to put oil in mercury villager?
Engine oil goes in the oil cap which is right on the front of the engine and has a picture of an oil can on it.
Can you put synthetic oil in a new engine?
yes you can synthetic oil can go in any engine
