When the mass air flow (MAF) sensor stops working, the engine control unit (ECU) may receive inaccurate or no data about the amount of air entering the engine. This can lead to poor fuel mixture, resulting in decreased engine performance, rough idling, stalling, and increased emissions. Additionally, the check engine light may illuminate, prompting the need for diagnostic testing and potential sensor replacement.
it prevents electricity to flow. i hope that is right
When you flip the switch to turn off the electromagnet, the flow of electric current stops, which in turn stops the magnetic field from being produced by the coil. The magnetic field is generated by the flow of electric current through the coil, so cutting off the current stops the magnetic field, causing the electromagnet to stop working.
Beavers build dams that stop the flow of water. When this happens, the wildlife in rivers suffer because the flow of water stops.
The heat sensor in the tub may be faulty. The heating element may be broken, but most of the time when this happens the breaker will through. If the tub has a circulation pump that is not working it will not close the in line flow sensor which will not alow the heater to come on due to low flow. Many flow sensors are clear and you can see it close when the system is running. check out these, and then replace whatever is broken.
no rubber stops the flow of electricity
When a circuit has a gap in it, everythig stops working because the electricity wont be able to flow around the whole circuit
If you are talking about a water pump then the kick-back is what happens when the pump is working and the water is flowing inside the pipe then when the pump stops the water flow suddenly stops as well and the column of water inside the pipe falls back because of gravity, if this is not prevented then the impulsor inside the pump, the seal or both can get damaged.
The energy to produce the light stops and the light stops.
It does not have a mass air flow sensor.It does not have a mass air flow sensor.
switch...this break the flow of electricity, from a circuit
Your mas air flow sensor could be goin bad. I have a 1996 probe and it runs great until you let off the gas then it dies evrytime instantly. Well it was MAF and TPS( mas air flow,Throttle position sensor)
It does not use a mass air flow sensor.It does not use a mass air flow sensor.