0
What else can I help you with?
When you apply the brakes why does the pedal depress all the way to the floor?
Check your brake fluid level in the master cylinder... you may have a leak some where
How to reset service light on Renault master?
it needs to be reset by computer Turn off power. Press accel pedal to floor. Turn keys two notches. While pressing the accel press brake three times. Depress accel and turn off keys.
Why do the brakes go to the floor before beginning to respond?
you either need a new brake master cylinder or your brakes need to be bled
Why would a brake pedal held to the floor suddenly lose tightness and brakes not working?
Have your brake system checked immediately! (by a proffesional)
You replaced rear brake shoes and drums your brakes are now fading and have to be pumped to stop There are no leaks and the adjustment is up where it should be?
Try bleeding your brakes. If there is air in the system it can give a spongy feeling to your brake pedal and require you to pump your brakes and/or put your brake pedal to the floor.
The brake pedal slowly creeps to the floor when you hold the brakes on a 1994 Ford F-350 with a Diesel eng.?
Check your brake fluid. Next maybe your brake lines need to be bled. OR you just might need new brakes.
Having brake problems on a 95 ford ranger xlt 2.3l v6 you replaced master cylinder brake booster bled the brakes pedal still goes to the floor?
You need to bleed the brakes.
What causes brake to go down to floor if brakes have been replaced?
Air in the brake system- Brake system needs to be bleed and fluid needs to be added while you are doing that.
Just changed your front and rear brakes and shoes. The brake light turns on until you put in more brake fluid. The brakes feel if they were almost touching the floor at times. What could cause this?
If you are losing fluid and the pedal is low, you have a brake fluid leak.
Brake pedal almost goes to the floor before it engages the brakes?
Probable causes: Low or no fluid in reservoir; Worn brake pads/shoes; Air in brake lines; Leaking brake line.
How to tell if you need your brakes replaced?
The best way to tell when you need brakes is by squeaking, when the brakes are rubbing against the metal, when your brake pedal goes all the way to the floor and when you are running out of break fluid.
When pressing brake have slight pressure initiallythen it goes to the floor If you hold the brake pedal to the floor you will have some breaking power Fluid levels are ok?
try and bleed brakes , if that wont work you need a master cylander
