there is a dipstick located about 6 inches behind the radiator on the right side or back of the engine. So if you open the hood and look at you engine, it will be on the right side at about 4:00 o'clock. make sure the car is on level ground, it is warmed up, and the shifter is in park.
ok, to start off, not trying to sound like a smartass or anything, but their is no dipstick on a manual transmission. their is a fill/check plug on the side of the transmission. you have to take it out and check the level that way on a manual transmission.
It "could" be that it is LOW on fluid in the transmission or the fuel filter is plugging up for a short period of time. Check the fluid level.
Same place you check the level.
You might want to ensure that the handbrake is completely released; you might also check the brake fluid level.
To add transmission fluid to a Mitsubishi 3000GT, first, ensure the vehicle is on level ground and the engine is warm. Locate the transmission dipstick, which is usually found near the back of the engine bay. Remove the dipstick, wipe it clean, and then insert it back to check the fluid level; if it’s low, use a funnel to add the appropriate type of transmission fluid through the dipstick tube. Be sure to check the fluid level again after adding, and avoid overfilling.
The 8.1 is a dry fill. You can only hold 5 because 3 qts still remain in the trans axle. Just measure the amount you took out if it is more then 5 qts then something is wrong. Check the level also via the dipstick. Mitsubishi needs to be running and in neutral to get an accurate reading.
To change the transmission filter on a Mitsubishi Mirage, first ensure the vehicle is on a level surface and secure it with jack stands. Drain the transmission fluid by removing the drain plug, then detach the transmission pan to access the filter. Replace the old filter with a new one, ensuring the gasket is in good condition, and reassemble the pan and drain plug. Finally, refill the transmission with the appropriate fluid and check the level.
The 2004 Mitsubishi Diamante typically requires Mitsubishi Diamond ATF or a compatible ATF such as Dexron III/Mercon. It's important to consult the owner’s manual for specific recommendations and to ensure the correct fluid is used for optimal transmission performance. Always check the fluid level and condition regularly to maintain the health of the transmission.
To check the automatic transmission fluid on a 1996 Mitsubishi Mirage, first, ensure the vehicle is on a level surface and the engine is running. Locate the transmission dipstick, usually found near the back of the engine bay, and remove it. Wipe it clean, reinsert it fully, then pull it out again to check the fluid level; it should be between the "full" and "add" marks. Additionally, inspect the fluid's color and smell—it should be a bright red color and free of burnt odors.
The 2001 Mitsubishi Galant typically comes with a 2.4-liter inline-4 engine as its base option, producing around 140 horsepower. Additionally, there is a more powerful 3.0-liter V6 engine available, generating approximately 190 horsepower. Both engine options are paired with either a 4-speed automatic or a 5-speed manual transmission, depending on the specific trim level and configuration.
You can check the transmission fluid level in your 1998 Chevrolet Corvette with the transmission fluid dipstick. The transmission fluid dipstick will have indicating marks as to the level of the transmission fluid.
How do you check the transmission fluid level on 1999 jetta GLS?