where is the right hand bank lambda sensor on a V12 1992 XJS
The reference sensor on a 1992 Jaguar XJS is typically located near the flywheel or the crankshaft, usually on the engine side of the transmission bell housing. Its primary function is to provide the engine control unit with information about the position of the crankshaft for proper timing and fuel injection. Accessing it may require removing some components for better visibility and reach. Always consult the vehicle's service manual for specific details and procedures.
Absolutely!
If a 1992 Jaguar XJS stops working, you can still raise the top. However, this can depend on what is broken. If the battery is dead, then you wouldn't be able to do this.
yes
The Jaguar XJS Convertible 4.0 has the horsepower of 233. The Jaguar XJS Coupe 4.0 has the horsePower of 233. The Jaguar XJS Convertible 6.0 has the horsepower of 302,As well as the Jaguar XJS Coupe 6.0. The Jaguar XJS Coupe 5.3 has the horsepower of 284,The Jaguar Coupe 6.0 has the Horsepower of 318. The Jaguar XJS Convertible 4.0 Consists of 226 horsepower,Then the Jaguar XJS convertible 5.3 has the horsepower of 284 horsepower. The Jaguar Convertible 6.0 has the horsepower of 318.
They are supposed to be replaced every 60,000 miles and are located underneath the chassis by the catalytic converters
In a 1989 Jaguar XJS, the temperature sensor is typically located near the thermostat housing on the engine block. It is usually positioned on the cylinder head or near the intake manifold, depending on the specific engine configuration. This sensor monitors the coolant temperature and sends signals to the engine management system and the dashboard gauge. Always consult the vehicle's service manual for precise information regarding your specific model.
In the boot, under the battery
I have a 1996 Jaguar XJS Convertible. It has a small backseat suitable for children.
The fuel pump is in the fuel tank.
In a 1992 Jaguar XJS V12 5.3, the OBD diagnostic plug is located under the dashboard on the driver's side. It is typically found near the steering column, often requiring you to remove a cover panel for access. If you're having trouble locating it, shining a flashlight in the area can help reveal the connector.