answersLogoWhite

0

What else can I help you with?

Related Questions

Is the vw 2.0t fsi a 16 valve engine?

Yes the VAG (VW/Audi) 2.0t FSI is 16 Valve. The older 1.8t it replaced was the Audi signature 5 valve percylinder engine.


How long is the 2003 Audi S6?

The 2003 Audi S6 is 16 ft. 1.4 in. (193.4 in.) long.


How long is the 2003 Audi A6?

The 2003 Audi A6 is 16 ft. 0 in. (192 in.) long.


How long is the 2003 Audi A8?

The 2003 Audi A8 is 16 ft. 6.2 in. (198.2 in.) long.


How long is the 2003 Audi S8?

The 2003 Audi S8 is 16 ft. 6.2 in. (198.2 in.) long.


Where is the pcv valve located on the 97 golf mk3 gl 16 please?

there isn't one buddy......


Where is the PCV valve for a Hyundai accent 16 liter?

your pcv valve is directly in front of the intake manifold silver unit that goes between the intake manifold and the throttle body it will have a connector coming from it. what this does it stops the engine from stalling and balances the idle. so as long as the check engine light is not on dont worry about it.


Where is the PCV valve located in a Toyota Corolla 2004?

where is the pcv valve located on a 2003 Toyota corolla? This does not help! 4 0r 6 cyl? either way the pcv (positive crankcase ventalition) valve is located on top of the valve cover(4cyl) or on one of the valve covers(6cyl) it has a pre-bent black hose from a vacuum source to the valve. if there are some miles on the car you will break the valve and hose(due to being brittle) how ever no worries, simply replace valve and use 5/16 fuel line to replace the pre-bent vac. hose. you may have to tie strap at both ends to keep the hose from coming off. the valve helps the engine from building up too much pressure resulting in oil leaks. good idea to change at tune-up time, but over looked by most techs. good luck. master tech 26yrs


Where is PCV valve located on 2002 ford escape 3.0 engine?

look below your throttle body, the pcv valve is buried in the -v- of the engine block itself, very hard to see. i removed mine by taking off the plastic engine cover, the one that says 24 valve v-6, then remove the rubber intake hose that's between the air filter box and the throttle body. this will give you enough room to remove the black vacuume hose that is connected to the pcv valve. now it gets tricky, you will need a 12 point deep well 7/8 socket, a swivel fitting, and an extension. fit the socket over the square on the pcv valve and rotate it 180 degrees counter clockwise, now you can remove the valve. to install the new pcv valve. i fit the small 3" vacuume hose we removed earlier over the valve, and put the other end of the hose in my 13/16 socket, and tightened the new valve into the block ( i did this because you can't reach the valve with your hand) 1/2 turn clockwise, do not overtighten! now, reconnect the 3" hose to the main pcv hose and reassemble your intake boot and engine cover. good luck


How many valves does the 2014 Audi TT have?

The 2014 Audi TT has 16 valves.


How many valves does the 2013 Audi TTS have?

The 2013 Audi TTS has 16 valves.


How many valves does the 2011 Audi TTS have?

The 2011 Audi TTS has 16 valves.