If I am not mistaken it is on the firewall behind the washer fluid holder. My went bad and I just wired a toggle swithch direct from fan motor, under the dash. It works fine just have no speed control, always on high when switched on
The blower motor resistor is located under the hood, in the right hand cowl, behind the windshield washer bottle.............
Its located under the hood in the right hand cowl behind the windshield washer bottle.........
The blower motor resistor on a 1993 Dodge Dynasty is typically located under the dashboard on the passenger side, near the blower motor itself. You may need to remove the glove compartment or lower dash panel for easier access. Once located, it is usually mounted to the HVAC housing with screws or clips. Always ensure the vehicle is turned off and the battery is disconnected before attempting to replace it.
In a 1991 Dodge Dynasty, the blower motor resistor is typically located under the dashboard on the passenger side, near the blower motor itself. You may need to remove the glove box or other panels for better access. It's usually mounted on or near the HVAC housing. If you're having trouble locating it, consult the vehicle's service manual for specific details.
To change the blower motor resistor on a 1993 Dodge Dynasty, first disconnect the battery to ensure safety. Locate the blower motor resistor, which is typically found near the blower motor itself, under the dashboard on the passenger side. Remove the electrical connector and unscrew the mounting screws to take out the old resistor. Install the new resistor in reverse order, reconnect the electrical connector, and test the blower settings before reassembling any panels.
The heater blower motor resistor on a 1988 Dodge Dynasty is typically located under the dashboard on the passenger side of the vehicle. You may need to remove the lower dash panel to access it. The resistor is usually mounted to the heater box and connected to the blower motor with wiring harnesses. Always consult your vehicle’s service manual for specific instructions and safety precautions.
The Blower resistor should be tested which is located near the blower motor, the resistor is probably faulty.
on the 89 dynasty, it is located right next to the thermostat
on the 89 dynasty, it is located right next to the thermostat
On the B250 van the blower resistor is located behind the passenger glove box, remove the glove box shell and resistor is located just to the right side, you can't miss it.
I have been working on an issue with my 2002 Dodge Ram. The blower motor and resistor are both located on passenger side under the dash. Easily accessible in cab.
Under the cowl where the wipers are. Remove that and two screws to pull resistor out.