answersLogoWhite

0

I've got an H reg vw polo and the release catch is on the left hand side below the glove compartment , about at knee height.

Pull it fairly hard and then open bonnet by releasing the safety catch at the front of the bonnet( bit fiddly first time, might need to use torch to get familiar with mechanism

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you release the bonnet catch of a vw polo manually?

To manually release the bonnet catch of a VW Polo, first, locate the release lever inside the car, usually found near the driver's side footwell. Pull the lever to release the initial catch. If the bonnet doesn't pop open, you can access the catch from the front grille by reaching through the gap or using a thin tool to push the latch upwards. Once the latch is disengaged, you can lift the bonnet.


How do you open the bonnet in VW Fox?

Volkswagen bonnet catch


How do i find front Vw polo windscreen washer bottle setup?

look under the bonnet!!


How do you release fuel cover vw polo 2002?

just pressit it pops open


Where is the VW Polo made?

New VW Polo for EU market is made in Bratislava, Slovakia.


How do you turn off airbag in vw polo 2000?

How do you turn off airbag in vw polo 1999


Where is the fuse box located for a 1988 vw polo?

The fuse box on a 1988 VW Polo is located under the dash, near the hood release. It contains most of the important fuses for the vehicle's electrical systems.


How do you open the bonnet on a VW Passat?

AnswerVW often puts the hood/bonnet release in the glove box or under it. Sometimes you will find it on the drivers side under the dash/steering wheel.


How do you open a bonnet on a vw passat?

AnswerVW often puts the hood/bonnet release in the glove box or under it. Sometimes you will find it on the drivers side under the dash/steering wheel.


How do you replace the bonnet release cable on a 97 VW Sharan?

To replace the bonnet release cable on a 1997 VW Sharan, first, open the bonnet and locate the release mechanism. Disconnect the old cable by unscrewing any fasteners holding it in place and then removing it from the latch. Feed the new cable through the same path, ensuring it is routed correctly, and reattach it to the latch and the release lever inside the vehicle. Finally, test the release mechanism to ensure it functions properly.


How to fit fuel pump in VW Polo?

Can someone advise how i fit an elecrtric pump to a vw polo twist?


How do you remove a VW polo badge?

Open the Bonnet, And Remove the Grill Look at the back of the Badge and seek the Holding Points , Turn or Pull in Correct way. Done Hope this helps regards Drew