0
On a 1978 Porsche 911 SC, the brake light switch is located on the brake pedal assembly. It is typically mounted on the pedal cluster, near the top of the brake pedal. To access it, you may need to remove the carpet and cover under the dashboard. The switch is activated when the brake pedal is pressed, completing the circuit for the brake lights.
What else can I help you with?
Why do brake lights on your 1978 Ford Fairmont come on when brake is pressed lightly but when pressed harder lights go out?
Probably a faulty brake light switch or the brake light switch is installed incorrectly.
How do you reset the brake light on a 1978 Ford Fairmont?
Make sure brake fluid is full check that emergency brake is released fully check equalizer valve (where brake light switch connects) remove wire loosen fitting and step on brake lightly to center piston in switch
How do you turn off brake light on 1978 Ford F150 4x4 pickup truck?
Check the operation and alignment of the brake light switch, located at the upper end of the brake pedal under the dash area
How do you turn off brake warning light on Ford F150 pickup truck 1978?
Make sure brake fluid in the master cylinder is at the proper level Make sure parking brake is fully released and switch is working
How do you fix brake lights on 1978 Oldsmobile 98 regency?
To fix the brake lights on a 1978 Oldsmobile 98 Regency, first check the fuse related to the brake lights in the fuse box and replace it if necessary. Next, inspect the brake light bulbs; if they are burned out, replace them with new ones. If the bulbs are fine, examine the brake light switch located near the brake pedal, ensuring it’s functioning properly and making a good connection. If these steps don’t resolve the issue, there may be a wiring problem that needs further investigation.
Where is the Brake Switch for 1978 Pontiac Trans Am?
The brake switch for a 1978 Pontiac Trans Am is typically located under the dashboard, mounted on the brake pedal assembly. It is activated when the brake pedal is pressed, completing the circuit for the brake lights. To access it, you may need to remove some under-dash panels for better visibility and reach. Always consult a repair manual for specific details related to your vehicle.
Where on a 1978 Jeep CJ5 do the brakes trigger the brake lights to work when the problem is that the rear turn signals work but not the brake lights?
The switch is located at the top of the steering column near the brake pedal. There is a bracket attached to the brake pedal that contacts and opens the switch when the brake is not being applied. Push on the brake the switch closes, and the lights come on. Look up the switch on Autozone.com or equivalent to see what it looks like. It's very hard to spot where it's at. Good luck Answer i believe there is a switch on the brake pedal lever near the top. I will go look on my jeep when I go back outside. Also, the brake light circuit has its own fuse separate from the signal lights.
Why isn't the brake lights not working on a 1978 ford pick up truck?
First check the fuse. If it is good, look under the dash and find the brake light switch. It will be mounted on the brake pedal lever or may be mounted so the brake pedal lever contacts it. It is adjustable and may just need adjusting. It the adjustment is correct, then replace it.
Why does your brake lights on your 1978 mone Carlo not work all fuses are good and grond wire good taillights work?
try brake switch under pedal
When was Porsche Tennis Grand Prix created?
Porsche Tennis Grand Prix was created in 1978.
1978 Ford F-150 truck?
there is the headlight switch in the dash witch turns them on and the relay on the floor by the e-brake that controls the high-low beams. that's about it
Neutral light on 1978 goldwing not coming on?
most likely neutral switch but check bulb first neutral switch is located right front under lower frame tube behind exhaust pipes
