The brake pedal sensor is typically located near the brake pedal assembly in the vehicle's interior. It is mounted on or near the brake pedal itself, sometimes attached to the bracket or the pedal arm. This sensor detects when the brake pedal is pressed and sends a signal to the vehicle's electronic systems, such as the brake lights and anti-lock braking system (ABS). Depending on the vehicle model, the exact location may vary slightly.
The brakelight sensor is located on the brake switch, which is on top of the brake pedal and held on with a 14mm jam nut.
You might need to replace the back-up light sensor, located under the dash, by the brake pedal. The correct term is "brake light switch" instead of "back up light sensor." And yes, it is located above the brake pedal.
The brake sensor for a 2004 GMC Envoy is typically located near the brake pedal assembly. Specifically, it is mounted on the brake pedal bracket and is often referred to as the brake light switch. This switch activates the brake lights when the pedal is pressed and can also be involved in the vehicle's cruise control system. For access, you may need to remove any surrounding panels or covers near the driver's footwell.
I should be just above the brake pedal where the shaft of the pedal pushes up against the switch. It should be easy to adjust or replace
The brake light sensor on a 2002 Lexus RX 300 is typically located on the brake pedal assembly. It is usually a switch that engages when the brake pedal is pressed, signaling the brake lights to illuminate. To access it, you'll need to look under the dashboard near the top of the brake pedal. If you're having trouble locating it, consulting the vehicle’s service manual can provide more specific guidance.
There is no brake light sensor. There is however a brake light switch. It may be mechanical, which would be located somewhere on the brake pedal lever. It can be bad or just out of adjustment. It can also be a pressure switch located on the master cylinder.
check fuses & brake lights switch located on brake pedal
brake light switch is above the brake pedal under the dash
look on the brake pedal lever.
Check the sensor on the brake pedal arm.
One may be located inside the master cylinder One may be located by the emergency brake pedal --upper end almost under dash
it is located to the right of the brake pedal