0
The camshaft position actuator on a Mercedes C230 is typically located near the front of the engine, integrated with the camshaft assembly. It is often found on the cylinder head, attached to the camshaft, and can be accessed by removing the engine cover. The actuator is responsible for adjusting the timing of the camshaft for optimal engine performance. Always consult the vehicle's service manual for specific locations and procedures.
What else can I help you with?
How do you change the thermostat on 2005 Mercedes C230 Kompressor?
How to change thermostat for mercedes c230
How do you fold rear seat of a Mercedes Benz c230 kompressor?
How to fold rear seat to mercedes c230 kompressor
How do you replace Mercedes c230 hood release strap?
How do u replace a hood release strap on a Mercedes c230
How do you set camshaft timing on Mercedes Benz C230 2003?
u need a special tool which holds camshafts in timing and crank needs to be 30 degrees after tdc.
Replace wiper blades on 2006 Mercedes C230 Sport?
How do you replace the wiper blades on a 2006 Mercedes C230 Sport
Where is aux jack in 2006 Mercedes Benz c230?
where can find the phone jack in 2006 mercedes benz c230 thanks
How do you remove shifter on Mercedes c230?
How do i remove a shifter on a mercedes
How do you replace serpentine belt tensioner on a Mercedes c230?
belt tensioner r@r 04 mercedes c230 1.8.sc
When was the Mercedes-Benz C230 manufactured?
The Mercedes Benz C230 was manufactured in 2000. This Canadian version of the Mercedes Benz C204 was produced until 2010 when it was renamed the C250.
Where is camshaft position sensor on Mercedes C230 kompressor?
There is an intake and exhaust cam sensor, both are located at the front of the engine in the head. They have 2 wire/pin connectors. They intake cam sensor is the one on the driver's side. See orange circle in picture/link below.
Were the battery for 2007 Mercedes c230?
All Mercedes have battery in the trunk
What is a service a in Mercedes-Benz c230 kompressor?
to repair Mercedes cars
