0
What else can I help you with?
Where is the coolant temperature sensor on a Fiat?
Under the Bonnet.
Where is the fan sensor on a Fiat bravo?
Cooling fan thermo switch is located on the radiator edit - only if fitted. Some fiat fans are controlled by the ecu, using data from the coolant temp sensor.
How do you bleed the coolant on a fiat bravo 1600?
To bleed the coolant on a Fiat Bravo 1600, start by ensuring the engine is cool and remove the radiator cap. Then, run the engine with the heater set to maximum until it reaches operating temperature, allowing any trapped air to escape. Keep an eye on the coolant level and add more if necessary to maintain it above the minimum mark. Finally, once the engine cools down, check the coolant level again and top off as needed.
Where is the crankshaft sensor on a Fiat bravo?
On the right side of oil cap in the rear side of motor... Also caled RPM sensor...
Where is the heater performance bank 1 sensor 2 on a fiat bravo?
This is part of the O2 sensor, check ahead of the catalytic converter(s) to find their location.
Where can I get a diagram of a Fiat Punto radiator to locate where to put the coolant in?
The Fiat Punto has a radiator which receives coolant in order to keep the temperature down. The diagram of this radiator can be found in the owner's manual.
Does a Fiat Stilo gearbox fit Fiat bravo?
yes
Where is the bonnet lever on a Fiat bravo?
the bonnet lever on a fiat brava is by the clutch pedel and has a red handle this may be the same on the bravo
How do you bleed cooling system on 1998 fiat bravo 1.4 12v?
To bleed the cooling system on a 1998 Fiat Bravo 1.4 12V, first ensure the engine is cool and remove the radiator cap. Start the engine and let it reach operating temperature, allowing the thermostat to open. Then, with the heater set to maximum, open the bleed valve (if equipped) or the highest point in the cooling system to release trapped air until coolant flows without bubbles. Finally, top off the coolant level and replace the cap.
How do you fit a hks dump valve to fiat bravo hgt 1997?
There is no point in doing that as the Fiat Bravo HGT has a Normally Aspirated engine ( no turbo)
Where is the coolant sensor located on a fiat ducat 2.8 jtd 2006?
The coolant temperature sensor on a Fiat Ducato 2.8 JTD (2006) is typically located near the thermostat housing, which is situated on the engine block. You can usually find it on the top or side of the engine, connected to the cooling system. To access it, you may need to remove some components for better visibility and ease of access. Always consult the vehicle's service manual for specific details and procedures.
Is there a car starting with the letter B?
fiat bravo
