next to the flywheel but you need to rimove the gear box fast
Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing.
where is the crankshaft position sensor on 2.5 liter vw jetta
the position off the crankshaft sensor
No such thing as Crankshaft sensor on VW Sharan. It has a Knock Sensor, dose the same thing as C/S but they call it Knock Sensor as it is not fitted to C/S or pully area. It bolts to the front of the engine near the gearbox and has a 10mm bolt holding it in place. 3 wires come from it at the front of the engine on a white plastic connector. -------------------------------------------------------------------------------------------- Strange as I replaced one this morning on a VW Sharon, ruling out any component without knowing the engine code is totaly worthless. and saying a knock sensor is the same as a crankshaft sensor is total bs. I suggest you only give advice when you know what your talking about my friend.
On the head
Crankshaft Position Sensor (CKP Sensor)
In line fuse on be crafter for cigarette lighter
There isnt one.
The oil filter on a crafter is to the left of the engine under the coolant reservoir.
It's inside the distributor housing.
The crankshaft sensor on a VW LT35 is typically located near the engine's crankshaft, often mounted on the engine block or the transmission bell housing. It is positioned to detect the position and rotational speed of the crankshaft, which is crucial for engine timing. To locate it precisely, consult the vehicle's service manual, as the exact placement can vary depending on the engine type and model year.
just aside of the oil filter, threaded into the bottom front of block.