If not working, check the horn 15amp fuse. when the horn doesn't work, neither does the criuse control.
Where is the ignition control module located in my 1992 Crown Victoria
On a 1992 Peterbilt, the cruise control pressure switch is typically located on the brake pedal assembly or near the throttle pedal. It is usually mounted on the brake valve or in the vicinity of the cruise control module. To access it, you may need to remove some panels or components in the driver's compartment for better visibility. Always consult the vehicle's service manual for specific details and diagrams.
The module is situated in the arm rest where you store stuff unscrew it and you will find the module.
On a 1992 Pontiac Trans Sport, the cruise control module is typically located under the dashboard on the driver's side, near the steering column. It may also be found on the firewall or attached to the engine compartment, depending on the specific configuration of the vehicle. To access it, you might need to remove some panels or components for better visibility. Always refer to the vehicle's service manual for exact locations and instructions.
Cruise Control - 1992 was released on: USA: October 1992 (Chicago International Film Festival)
The ecm is under the dash above the glove box. Above and to the left of that ( smaller box ) is the cruise control module.
Hopefully, you have had the cruise control module recall work done. It's free at any Ford, Lincoln or Mercury dealership. It can start a fire and be very dangerous. Take it to dealership right away.
Change the cruise control switch.
Dateline NBC - 1992 Cruise Control was released on: USA: 7 May 2006
the horn is located on the steering wheel along with the accel set button and cruise control button.
It should be on your drivers side fender, right next to your coil.
be hind glove box its silver and looks like a vcr tape