under the bonnet
A problem with the ABS has been detected - it could be a sensor , a fuse , your brake fluid level in the brake master cylinder might be a little low , the wiring connection to the ABS control unit etc , take it to a professional and get it checked out.
A problem with the ABS has been detected - it could be a sensor , a fuse , your brake fluid level in the brake master cylinder might be a little low , the wiring connection to the ABS control unit etc , take it to a professional and get it checked out.
If the ABS light is also on, the speedometer will work intermitly. ABS module must be repaired. It costs about 200$ to 300$ (Can) to repair. You should also take the fuse off for the abs control unit until it is repaired... it's the second fuse I think (not sure, check the diagram).
Follow the 2 brake lines that lead out of the master cylinder, they run to the ABS unit.
Pull the ABS fuse located in the engine bay. This disables both traction control and ABS. The lights on the dash will stay illuminated because of the missing fuse.
The ABS pump relay is intergrated into the EHCU (elecro-hydraulic control Unit) and it is not serviceable. If the ABS pump relay is defective, the entire control unit must be replaced.
pull the abs fuse
How do you disable the ABS Control on a 1999 Venture?
pull abs fuse out inside fuse box
TCS communication line - ECM can not receive the information from "ABS actuator and electric unit (control unit)" continuously.Possible Causes:Harness or connectors (The CAN communication line is open orshorted.)ABS actuator and electric unit (control unit).Dead (Weak) battery
There could be something wrong with the ABS system and check the ABS sensors on all wheels. Also check the connections to the ABS unit and the traction control button.
ABS fuse is located in the engine compartments fuse block, the owners manual ussually lets you know where the fuse is and the amperage.