There is no dipstick for the gearbox
the punto has a filler/level plug on the front of the gearbox
12mm Allen key fitting
hope this helps
best wishes
Mike 2
A 1996 Punto 55 uses a single point (non-direct) fuel injection system. Later models adopted a multi-point injection system but none of the Fiat 1.1 engines use direct injection.
Under the rear seats. Remove 3 screws from the metal plate and there it is.
Fiat do not issue torque settings for a punto they use angles so that you can snap your stretch bolts! after contacting fiat and haynes neither of them would give proper torque settings, so i delved into my many tech manuals on fiat fire engines which is what is in your punto and i have successfully changed many fiat punto head gaskets using the following torque settings: stage 1 starting from the centre head bolts tighten to 33nm: stage 2:65nm and finally stage 3: 96nm these torque settings work fine and will probably save you buying new head bolts.
The rear heater relay on a Fiat Punto 55 S is typically located in the fuse box, which is found under the dashboard on the driver's side or in the engine compartment. To find the specific relay, refer to the vehicle's manual for a diagram of the fuse box layout. Usually, the relay will be labeled, making it easier to identify. If you have difficulty locating it, a visual inspection of the fuse box may help.
To add gearbox oil to a Fiat DT 55 66 tractor, locate the fill plug on the gearbox, typically found on the side or top of the housing. Remove the plug and use a funnel to pour in the appropriate type and amount of gearbox oil as specified in the tractor’s manual. Ensure the oil level is at the recommended height by checking the level through the fill hole before replacing the plug. Always consult the owner’s manual for specific oil type and capacity.
Idle settings 0.8 bar (11.6 psi ) to 1.2 bar ( 17.4 psi ) best wishes Mike 2
In a nut shell you cant adjust pedal height of any car. Unless you spend serious money on an exotic sports car.
i asume you know your spanners so to help you on your way the torque settings are Fiat Punto 55/60 1.1/1.2 engine make sure you use new bolts ect. Stage 1 30Nm/22LBf ft Stage 2 59Nm/43.5LBf ft Punto 55 engine code 176A7.000 Torque figures stage 1. 20 newton metres stage 2. 30 newton metres stage 3. + 90 degrees stage 4. + 90 degrees torque sequence 8 6 2 5 10 7 3 1 4 9 bolts 9 & 10 are the flywheel side of the engine
The rear track of the 2014 FIAT 500 is 4 ft. 7 in. (55 in.).
The rear track of the 2013 FIAT 500e is 4 ft. 7 in. (55 in.).
The rear track of the 2013 FIAT 500 is 4 ft. 7 in. (55 in.).
The rear track of the 2014 FIAT 500e is 4 ft. 7 in. (55 in.).