3, all located ontop of the ignition control module.
Assuming this has the 3.8 V-6 engine, the three coils are plugged into the ignition module.
Lower passenger side of engine block, the coils are attached to it.
Part of the coil mounted to the fire wall
Begin by removing the wiring harness from your 1998 Chevrolet Suburban ignition module. Remove the ignition module retaining screws. Reverse the process to install your new ignition module.
The engine computer is also the ignition module.
under the ignition coils. it is flat comes off after you remove the three numbered igniton coils. they plug into the module underneath them.
In a 1998 Buick Century, the ignition control module is typically located on the side of the engine, mounted on the ignition coil assembly. It is usually positioned near the front of the engine, accessible from the top or side. You may need to remove some components for easier access, depending on the engine configuration. Always consult the vehicle's service manual for precise location details and safety precautions.
ignition timing is controlled by the electronic control module or the "brain" on distributorless engines. Reysher
The power door lock control module should be in with the jack or next to that compartment.
In a 1998 Monte Carlo, the ignition coils are typically located on the engine's intake manifold, mounted directly on top of the spark plugs. The ignition control module (ICM) is usually found near the ignition coils, often attached to the engine or firewall. You may need to remove the engine cover or other components for better access to these parts. Always refer to a service manual for the exact location and any specific procedures for your vehicle.
how do you replace a wiper control module in dodge 1998