in dash glove box
by the fuses
To wire a range hood in a kitchen, follow these steps: Turn off power to the kitchen circuit at the breaker box. Install a junction box near the hood location. Connect the hood's wiring to the junction box, following the manufacturer's instructions. Secure the wiring with cable clamps and cover with a junction box cover. Turn the power back on and test the range hood to ensure it is working properly.
There are 3 fuses involved in the charging circuit. #227 10A in the central junction box under left side of dash. #126 30A in the battery junction box on the front center of engine compartment. And the mega fuse 175A on the battery junction box.
Yes, you can install a junction box in the cupboard to extend the wiring for the new range hood. Make sure to follow electrical codes and safety guidelines when installing the junction box and connecting the wiring. It may be helpful to consult with a licensed electrician for proper installation.
press the big button above with the keyhole on it.
it should be the box on the top right of your engine.
Yes, the outdoor junction box is waterproof.
They are in the central junction box. [the fuse box under the dash] But they are integral with the box. You have to remove the fuse box, take it apart, and they are inside, soldered in. If you can solder, you can replace them.
i belive its i a pannel as u open the drivers door on the side of the seat
In a snap panel in the glove box just under the CD multichanger.
on a rhd it is behind the panel, which is below the glove box on the passenger side