On the sump which can be accessed by jacking up the front of the car. climb underneath after securing the vehicle in a raised position and the sump plug will be on the lowest point of the engine pointing towards the back of the car and slightly down.
Under the engine, towards the back of the sump.
To change the oil on a Peugeot 306, first, warm up the engine to thin the oil, then turn it off and allow it to cool slightly. Place a drain pan under the oil pan, remove the drain plug, and let the old oil fully drain out. Replace the drain plug, remove the old oil filter using an oil filter wrench, and install a new one with a bit of oil on the gasket. Finally, refill the engine with the appropriate type and amount of new oil through the oil filler cap.
Lots of oil seals on a 306 need to know which one
on the side of gearbox at top a remove ns wheel to see it its an 8mm hexagen shaped bolt
To change the gearbox oil on a Peugeot 306 petrol, start by ensuring the vehicle is on a level surface and secure it with wheel chocks. Remove the drain plug from the gearbox and let the old oil drain completely into a container. Once drained, replace the drain plug and remove the fill plug on the side of the gearbox. Using a funnel, add the recommended gearbox oil until it reaches the fill level, then replace the fill plug securely.
use the dipstick
probably 10W40
5w40
Where is the oil drain bolt on a 2004 Toyota Rav4?
10w40 is fine
The gearbox oil fill plug can be located, in your Peugeot 306 2.0, on the top of the gearbox nears the back. The plug can be removed with a three-quarter inch socket
4 quarts