answersLogoWhite

0

Under the car on the front exhaust silencer box.

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you replace the oxygen sensor on a Renault Clio 2003?

its located just before the catalyst. Unlplug it then using an oxygen sensor socket carefully undo it. it will be very very tight due to the temperatures it experiences, be careful incase you shear it off!


Where is lambda sensor located on clio 1995?

Lambda is o2 sensor in exhaust pipe.


Where is crankshaft sensor Renault clio?

The crankshaft sensor Renault Clio is located on the bottom of the engine, near the oil filter. It is connected to the vehicle's computer and constantly provides information about the position of the crankshaft.


Where is the locations of oxygen sensor for Mitsubishi Outlander?

There are two oxygen sensor for Mitsubishi Outlander. Front Oxygen Sensor and Rear Oxygen Sensor


Where is IAT sensor on a 1.8 clio rsi?

Inlet air temperature


Do you need a oxygen sensor for headers?

If the vehicle was built with an oxygen sensor, you will need an oxygen sensor.


Renault Clio 1998 Speedometer sensor or cable?

If it's a Mk2 Clio then the speedo is electronic - Mk1 Clios had cable driven speedos.


Clio not generating ignition spark?

My clio wouldn't spark the other day. Turned out to be the crankshaft sensor. Apparently a common fault on clios.


Where exactly is the location of your oxygen sensor heater in a 2002 rodeo?

It's integrated into the oxygen sensor. Buy a new oxygen sensor and you get a free oxygen sensor heater.


Change oxygen sensor on 95 Oldsmobile cutlass ciera?

Remove the oxygen sensor vacuum to. Remove the oxygen sensor screws. Reverse the process to install the new oxygen sensor.


Ford Fiesta oxygen sensor replacement?

Remove the vacuum hose from the oxygen sensor. Remove the oxygen sensor retaining screws. Reverse the process to install the new oxygen sensor.


How to replace oxygen sensor on a 2002 ford explorer xlt?

To replace the oxygen sensor disconnect the oxygen sensor electrical connector. Use an oxygen sensor socket to remove the sensor. spray the sensor with penetration oil if it is difficult to loosen. install in reverse.