On a 2000 Porsche Boxster, the parking brake sensor is typically located on the parking brake mechanism itself, which is situated in the center console. It is connected to the lever assembly and activates a warning light on the dashboard when the parking brake is engaged. To access it, you may need to remove the center console trim. Always consult the vehicle's service manual for specific instructions and safety precautions.
If the top still won't close with the key turned to "on" or with car running make sure the parking brake light is on. If it isn't your parking brake sensor is bad and you need to go to a shop to have it replaced. In the mean time try releasing and reengaging the parking brake a couple of times to see if you can get the sensor to trigger and come on. If that works don't put the top down again until you get the sensor replaced. Put car in park or neutral, set emergency brake,and while car is 'on' or running, push the switch to close roof. Hold button down til roof is all the way up, latch in place.
If the top won't close with the key turned to "on" or with car running and the parking brake engaged make sure the parking brake light is on. If it isn't your parking brake sensor is bad and you need to go to a shop to have it replaced. In the mean time try releasing and reengaging the parking brake a couple of times to see if you can get the sensor to trigger and the brake light to come on. If that works don't put the top down again until you get the sensor replaced. Or it might just need a new fuse.
Faulty or over sensitive parking brake switch or sensor.,
Low brake fluid in master cylinder, fault in brake fluid level sensor, parking brake is on, parking brake sensor fault.
there are under the brake pedal a switch which control brakes ligths . You may check the swich after checking fuses,and bulb.
it is behind emergency brake on top!!
To reset the brake wear light on a 1999 Porsche Boxster, first ensure that the brake pads have been replaced and the wear sensors are properly connected. Then, turn the ignition key to the "On" position without starting the engine. Press the brake pedal several times to allow the system to recognize the new sensors. Finally, turn off the ignition and start the engine to confirm that the brake wear light has been reset.
the parking brake is either sticking or the sensor is bad This could also be a warning that there is something wrong with the braking system. The light is not only for the parking brake in most vehicles.
usually the parking brake sensor is malfunctioning [or the fluid is low check this first]
You might have an ABS problem or a problem with the brake master cylinder. Check the fluid level in the brake reservoir.
Does it have abs, are there wear sensors for the pads, is your parking brake properly adjusted, is your parking brake lever switch to notify you of brake engaged making contact. What is your fluid level does it have a sensor is that sensor working, Need more info. to better understand situation.
This light is for brake on/problems with the brake. Check your brake fluid level and ensure it isn't dipping below the sensor on the master brake cyllinder. I had this happen to me during winter.