answersLogoWhite

0

What else can I help you with?

Related Questions

How do you reset trip odometer in 2008 c300?

To reset the trip odometer in a 2008 Mercedes-Benz C300, press the "Trip" button located on the instrument cluster until the trip odometer you want to reset is displayed. Then, press and hold the same "Trip" button for a few seconds until the reading resets to zero. Make sure to release the button once the reset is complete.


How do you reset your indicator lights on your Toyota Highlander?

For Maintenance Required warning light on 2008+ Highlander Hybrid: Start from car in OFF mode. Keep foot off brake pedal, press START/STOP botton twice, reset odometer A & B. While in odometer A, press & hold odometer reset button and simultaneously press START/STOP button to turn off. Press & hold odometer reset button and simultaneously press START/STOP button twice. Wait for the indicator bar to complete reset cycle and then release odometer reset button.


How do you activate a new key on a 2008 ford 150?

Turn the key to the ON position. Set the odometer to show the total miles (NOT THE TRIP). Turn the key to the ACC position. While holding the odometer reset button, turn the key to the ON position. The odometer will count down from 5 and reset. Release the reset button. DONE


How do you reset service light 2008 VW Jetta?

I had the same issue. This worked for me. "With the doors closed put the key in the ignition. Hold down the trip odometer reset button. Turn the key to the on position. You will see the service indicator light (wrench). Press the minute adjustment button. Release the trip odometer reset button." I tried the same thing on my 2009 Jetta and it worked! (I have over 60,000 miles on it and opted to have the oil change and fuel filter done outside VW) When I left the Service Now still came on. So when I got home I ran a search and found the answer. Thank YOU!


How do you reset the warning light on a 2008 vw jetta city half circle with an exclamation mark inside?

The tire pressure warning light on a 2008 VW Jetta City , parenthesis enclosing an exclamation point, can be reset once the pressure is restored. Press the set button on the dashboard.


Oil light reset button for a 2008 Honda civic si?

On the odometer, go to where it tells you OIL LIFE function... HOLD the button down for 10 seconds and it will start blinking at you. From there, you will hold the button down again for another 10 seconds and it will reset itself!


Where is the odometer knob in 2008 seat leon?

In the 2008 Seat Leon, the odometer knob is typically located on the instrument cluster, near the speedometer. It may be integrated into the dashboard controls or as a separate button. To reset the trip odometer, you usually need to press and hold this knob or button for a few seconds. Always refer to the vehicle's owner manual for precise instructions.


How do you reset service light on a 2008 volkswagon jetta?

With the key in the ignition (but not turned), press and hold the Odometer Reset Button (0.0) on the right hand side of the panel. While still holding that button, turn the key (although not far enough to start the engine) and then press and hold the Minute button on the left side of the instrument panel. Release both buttons at the same time. Try to reset the light as close to the actual service time as possible, because you don't want to risk any problems or confusion.


How do you reset oil light in 2008 Honda accord?

With the ignition off, push and hold the odometer reset button, now turn the ignition on without starting the engine. After 5 seconds the maintenance required light will go out and reset.


How do you reset Service Reminder Indicator of a 2008 Volvo V70?

To reset the Service Reminder Indicator on a 2008 Volvo V70, first turn the ignition to the "ON" position without starting the engine. Press the trip odometer reset button (located on the dashboard) and hold it down. While holding the button, turn the ignition off and then back to the "ON" position again. Release the button, and the Service Reminder Indicator should be reset.


How do you reset the maintenance required light in a 2008 Highlander with key less entry?

First, reset both trip meters (A and B). With the Accessories on, depress the odometer button while on trip A and Press the ON/OFF button to turn off the Accessories. While pressing the odometer button Press the ON/OFF button twice to turn the Accessories on and you will see in the display screen bars disappearing and the maintenance reminder message resetting.


How do you Reset Service Reminder in 2008 V70?

Unfortunately you will have to take it to the garage to be reset. As far as I am aware there is no simple method, like turning the ignition on and off whilst holding the odometer button, as on previous models off the V70.