The air conditioning recharge port on a Vectra C is typically located on the low-pressure side of the AC system. It can usually be found near the front of the engine bay, close to the compressor, and is often identifiable by a blue or black cap. To recharge the system, you'll need to connect your AC recharge kit to this port. Always consult your vehicle's manual for precise location and safety instructions.
Its located on the top of the a/c compressor..................
Recharge port for 99 blazer is located on the passenger side close to the firewall on the upper side of the silver cylinder tank located there. Trace your a/c hoses from your a/c unit across engine compartment. The larger line connects into the side of this tank. Black cap on port screws off to reveal quick connect recharging port. Smaller line from a/c unit also has a quick connect port with black cap. Single hose recharge kits(134a) will only fit recharge port on side of tank. On the opposite side of tank is the low pressure cut off switch and wiring plug for your a/c unit. This switch prevents a/c unit from coming on if refrigerant pressure is too low.
where is the low pressure port for the a/c -- 93 ford ranger 4.0L -- super-cab
Will a tow bar of a vectra b fit a vectra c
Follow the larger line from the a/c compressor
Follow the larger line from the a/c compressor
On the low side service port that is located on the a/c compressor manifold.....
vectra b is the earlier engine
Look under car...look for blue c as p near compressor...
The low side recharge port on a 2003 GMC Envoy is located on the passenger side of the engine compartment. Specifically, it can be found near the rear of the engine bay, on the A/C line that runs from the evaporator to the compressor. The port is typically marked with a blue or black cap. Always ensure to use the correct refrigerant and follow safety precautions when recharging the A/C system.
To recharge the air conditioning in your 2003 Tiburon, first, locate the low-pressure service port, typically found on the larger A/C line. Use an A/C recharge kit that includes refrigerant and a pressure gauge. Following the instructions, connect the hose to the port, start the engine and A/C, and add refrigerant until the gauge indicates the correct pressure. Always ensure to check for leaks and consider consulting a professional if you're unsure about the process.
Probably not has they never work. On vectra b theres a nut under the handbrake gattor, not sure if its same on vectra c