The DTC reset switch for the Opel Astra LZ2 with a petrol engine is typically located under the dashboard, near the driver's side, or in the engine compartment. It may be found near the fuse box or attached to the engine wiring harness. Consult the vehicle's owner's manual for the exact location, as it can vary by model year and specific configuration. If in doubt, a professional mechanic can assist in locating it.
hold milage reset button in and switch on ignition.hold for about 5 seconds and it will reset.
Press and hold the mileage reset button turn the ignition on wait for 4 dashes to appear, switch ignition off job done ! this will not work. this only resets your service light and not the engine managent light.
No reset switch on a Dodge Ram.
Dodge does not have a reset switch.
There is no tire pressure warning manual reset for the Astra. Make sure that the tires are properly inflated, and let the engine run for about 10 minutes. If the system is working correctly, then it will reset itself.
A 2002 Jeep Wrangler does not have a reset switch.
To reset the service indicator on an Astra H, turn on the ignition without starting the engine. Press the accelerator pedal three times within five seconds. Then, turn off the ignition and start the engine to check if the service light has been reset. If successful, the indicator should no longer be illuminated.
There is no fuel reset switch. There is a fuel pump fuse within the fuse box and there is a relay inside of the electrical panel in the engine compartment, but there is no reset switch.
To reset the service warning light on a Vauxhall Astra, turn the ignition key to the "ON" position without starting the engine. Press the accelerator pedal three times within five seconds, then switch off the ignition. Turn the ignition back on, and the service light should be reset. If it doesn't turn off, repeat the process or consult the owner's manual for specific instructions for your model year.
There isn't a reset switch. The light is reset with a scan tool after the cause of the trouble code has been repaired.
If you are looking for an inertia/reset switch, the answer is no. The engine computer controls the fuel system with relays.If you are looking for an inertia/reset switch, the answer is no. The engine computer controls the fuel system with relays.
A Chrysler LeBaron does not have a reset switch. The fuel pump is controlled by the engine computer with relays.