The bentley manual "green book" has all the wiring diagrams you need.
I need a wiring diagram for the battery, starter, and solenoid of a 1971 Chevy truck, 350.
To replace the turn signal switch on a 1971 Chevy Pickup, first disconnect the battery to ensure safety. Remove the steering wheel by loosening the retaining nut and using a puller to detach it. Then, take off the steering column cover and locate the turn signal switch attached to the column; disconnect the wiring harness and remove the switch by unscrewing it. Install the new switch by reversing the procedure, reconnecting the wiring harness, and reassembling the steering column and wheel.
The Library
http://www.thesamba.com/vw/archives/info/wiring/bug_std_super_72.jpeg
On e-Bay!!
look online.
The wiring diagram of the ignition on a 7.5 HP 1971 Thunderbolt shows exactly how each component is connected. This makes the process of electrical repairs much easier.
To replace the turn signal on a 1971 VW Beetle, first, disconnect the battery for safety. Remove the screws securing the turn signal assembly, typically located on the steering column. Carefully detach the old turn signal by pulling it off and disconnecting the wiring harness. Install the new turn signal by connecting the wiring, securing it in place, and then reconnecting the battery to test for proper function.
To change the ignition switch on a 1971 VW, first disconnect the battery to ensure safety. Remove the steering column cover by unscrewing any screws or clips holding it in place. Locate the ignition switch, disconnect the wiring harness, and unbolt the switch from the column. Replace it with the new switch, reconnect the wiring, reassemble the steering column cover, and reconnect the battery.
http://www.thesamba.com/vw/archives/info/wiring/bug_71.jpg and http://www.thesamba.com/vw/archives/info/wiring/bug_7071_key.jpg
I believe the hazard switch is used as the turn signal flasher in 71 bus. No extra flasher involved... I believe the hazard switch is used as the turn signal flasher in 71 bus. No extra flasher involved...
To remove the convertible top switch on a 1971 GTO, first disconnect the battery to ensure safety. Then, use a flathead screwdriver to carefully pry off the switch cover plate if applicable. After that, disconnect the wiring harness from the switch and unscrew the switch from its mounting location. Finally, gently pull the switch out of the dashboard area.