The VW Beetle has 2 jack points, one on each side to the rear of the front door. The body/pan assembly is ridged enough that this single jack point will lift the entire side of the car.
If your car is tatty, or does not have a jack point installed, place a floor jack under the front bulkhead of the car, and raise the entire front end.
To lift a VW Super Beetle, place the jack under the designated jacking point, which is located near the front or rear suspension. For the front, position the jack under the center of the front beam, just behind the axle. For the rear, place it under the rear axle or the torsion bar. Always ensure the vehicle is on a level surface and use jack stands for safety once lifted.
Lift points on the side Just in front of door Just in front of rear tire
With a jack.
Lift front hood Remove cardboard covering over the dash panel area. Locate the lamp holders and replace lamps as required. Reassemble.
The boot or the trunk is under the front hood of a 1967 VW Beetle. To open the hood, make sure the handle is unlocked, turn the handle to the right and lift.
The best way to lift the front of a Vehicle to work on it is to use a trolley jack. With a trolley jack , make sure you use the jack stands just in case the jack slips. You wouldn't want to be crushed.
with a jack
From the sides behind front wheels there is a member pad. In front of the rear wheels there is a pad for jack. Do not lift from side of body or center of rear wheels. It is OK to lift from front center of cross member.
Anywhere on the frame. On the rear, use the axle. In the front, there are tabs designed for your jack and they can be seen in front of the axle.
To change the transmission mount on a 1973 Super Beetle, first, safely lift and secure the vehicle. Remove the bolts securing the transmission to the mount, then support the transmission with a jack. Unbolt the old mount from the chassis and install the new mount in its place. Finally, reattach the transmission to the new mount and lower the vehicle, ensuring all bolts are tightened to the manufacturer's specifications.
of course! can you?
Using the factory jack : On the front there is a hook on the front of the lower control arms On the back place the jack under the axle tube below the leaf spring