Hello There is no fuse that controls the radio speakers that i know about. You need to check the speakers first they could be blown. To do this use a 9 volt battery to check the speakers. First locate the wires going to one speaker and use the battery to check them. put one wire on one speaker lead and the other on the other lead if the speaker moves then its good if not then its bad. Repeat this process for all speakers. sounds like you have a radio problem i would highly recomend checking it out first. good luck joe
Need a little more information: After-market or factory stereo? Are you doing speakers as well? Do you know if any wiring will need repair?
Depending on what year model 1990-1999 is either 6x8 (5x7 is the same thing) or 6.5". The 1996 Ford Ranger XLT model the front and rear speakers are 6x8(5x7).
in the stereo
Death by Stereo was created in 1996.
Stereo - Pavement song - was created in 1996.
1996 ranger does not have speedo cable it is electronic
To remove the factory stereo on 1996 dodge ram 1500 you need to pop the hood on the Ram and remove the ashtray. Slide the stereo out of the dash and unplug the cables from the back of the stereo.
under the hood in the power dist box it will be the first big fuse (red) at the firewall closest to the fender
The front speakers are 4" and the rear speakers are 6 1/2".
where is the fusible link on a 1996 ford ranger xlt
5W-30 oil is used in the engines of a 1996 Ford Ranger
they are 6x9 speakers and hard to get out