It contains two relays, one for hazard lights and the other for turn signals. The one for the turn signals is defective and must be replaced.
Signal lights staying on withot flashing indicates either front or rear signal bulb not working on the Audi
What do the flashing words 'service inspection' mean on a 1998 Audi A4 1.9 tdi
what does INSP mean? this came out in my 1998 Audi A4 1.8T.
It could be the indercator switch i just had the same fault on a Hyundai and it was the indercator switch
Dealer's parts department.
fuse
Heater has just stoped working no power to control panel
It's built into the hazard light switch. The hazard light button will slide out, with the relay (small box) attached.
To jump-start an Audi A6, first ensure both vehicles are turned off. Connect the positive (+) terminal of the dead battery to the positive terminal of the working battery, then connect the negative (-) terminal of the working battery to a grounded metal surface on the Audi (not directly to the negative terminal). Start the working vehicle and let it run for a few minutes before attempting to start the Audi. Once the Audi starts, disconnect the cables in the reverse order, ensuring not to let the clamps touch each other.
Driver Information System not working
i have a Audi a3 and my indercaters work and then they stop what could it be.
If your hazards still work, most likely your turn signal relay needs to be replaced.