On the brake pedal nr the top you will see a switch it as two wires it may be jammed or need adjusting.
You have to repair the part that caused the light to come on.
When the handbrake and stop light on a Renault Clio come on, it typically indicates that the handbrake is engaged or not fully released. Additionally, it could signal an issue with the brake system, such as low brake fluid levels or a problem with the brake components. It's important to check both the handbrake and brake fluid levels, and if the warning persists, to consult a mechanic for further inspection.
The red light is the sign to come to a complete stop. That's what a red light means. Come to a complete stop!!
service light and abs light on my clio 172 sport how do i reset thanks
The Renault Clio comes from France.
on a mk1 clio just unscrew the screws in the front of the lamp and pull it out, twist the plug at the back and it should all just come appart
i own a 1998 clio 1.4RT mine dont light up..... i own a 1994 clio 1.2RL an mine dont light up either!!! Hi I own a 1995 Clio 1.4 RT mine dont light up.......... Yes and the bulb was a right pain to change, the setreo and half the plasic surrounding the controls has to come out
Your vehicle must come to a stop at the white stop line or before the crosswalk when there is a stop sign or red light.
What does the coi pack light look like on a Renault clio
The red warning stop light on a Renault Clio indicates a serious issue that requires immediate attention. It can signify problems such as low oil pressure, overheating, or a malfunction in the braking system. When this light comes on, you should pull over safely and turn off the engine to prevent potential damage. It's advisable to consult the vehicle's manual or a professional mechanic for further diagnosis.
To change the rear stop light on a 2009 Renault Clio 1.2, first, open the rear hatch and locate the tail light assembly. Remove the screws or clips holding the assembly in place and gently pull it out. Disconnect the electrical connector and twist the bulb holder counterclockwise to remove it. Replace the old bulb with a new one, reassemble the components, and test the light to ensure it works properly.
Red Stop Light Flashing Red Stop Light Red Stop Sign