answersLogoWhite

0

Mine does

User Avatar

Wiki User

17y ago

What else can I help you with?

Related Questions

How do you change fan belt on a rover 414?

,


Where do you put oil in a rover 414?

in the rocker cover


What are the torque settings for rover 414 wheel nuts?

something around 110Nm


Where is the adjustable nut for the clutch on rover 414 1999?

there is none it,s a hyrdaulic system


What do you do if your rover 414 has cold air blowing out of the heater?

If your Rover 414 is blowing cold air from the heater, first check the coolant level in the reservoir, as low coolant can prevent the heater from functioning properly. If the coolant is at an adequate level, inspect the thermostat to ensure it’s opening and closing correctly. Additionally, check for any air pockets in the cooling system that may need to be bled out. If these steps don’t resolve the issue, it may be necessary to consult a mechanic for further diagnosis.


How many rover 414 saloons on road?

As of my last update in October 2023, specific data on the number of Rover 414 saloons currently on the road may not be readily available. The Rover 414, a model produced in the 1990s and early 2000s, is considered a classic and has likely seen a decline in numbers over the years. For the most accurate and up-to-date figures, you may want to check with vehicle registration databases or classic car registries.


What type of oil do you need for a s reg rover 414?

10W-40 (per the haynes manual)


Why wont your rover 214 start?

my rover 214 sli is very hard to start from cold once its going its no problem i took the filter cover off poured a little petrol into the carb and away she goes?


Why will a 1988 Land Rover try to start but won't when it is cold outside but will start when the sun has been on it for a few hours?

automatic choke not working properly


Where is the thermostat located on a rover 414?

On a Rover 414, the thermostat is typically located near the engine, often on the engine block or in the coolant housing. It's usually situated along the upper radiator hose, which connects the radiator to the engine. For precise location and access, it's advisable to refer to the vehicle's service manual, as configurations can vary.


Were to pour sodium silicate in your rover 414?

You add it to your water tank this is used to stop oil leaks in engines, follow instructions to the letter or it will not work.


What causes misfires in range rover?

Range Rover Classic EFI will foul spark plugs if you start and stop the engine when cold. All models with 3.5, 3.9, 4.2, 4.0, 4.6 will wear out camshafts and/or blow headgaskets from 150,000km to 200,000km.