If the clutch pedal in a Porsche Boxster won't work after a jump-start, it could be due to a few reasons. One possibility is that the jump-start affected the vehicle's electrical systems, including the clutch master cylinder or its hydraulic components. Additionally, there may be an issue with the clutch hydraulic fluid, such as low fluid levels or air in the system. It's also possible that the battery or electrical system is not providing adequate power, affecting the operation of the clutch.
for my 2002 boxster (not a sport) there is an unmarked raising/lowering switch on the drivers side near the floor close to the clutch pedal. hope that helps.
The fuse box in the 996 (911) is in the lateral wall of the pedal well, to the left of the clutch pedal.
there are under the brake pedal a switch which control brakes ligths . You may check the swich after checking fuses,and bulb.
To reset the oil change light on a 2005 Porsche Boxster S, turn the ignition on without starting the engine. Press the gas pedal fully three times within five seconds. After releasing the pedal, the oil change light should reset. Finally, turn off the ignition and then start the engine to verify that the light is no longer illuminated.
To reset the service indicator on a 2005 Porsche Boxster, turn the ignition to the "On" position without starting the engine. Press and hold the gas pedal while simultaneously pressing the brake pedal for about 10 seconds until the service light blinks and then goes off. Release the pedals, and the service indicator should be reset. If the light remains on, you may need to consult the owner's manual or a professional for further assistance.
The clutch pedal cannot be adjusted
The clutch pedal.
obviously you have a clutch line or slave cylinder leak.
To adjust the clutch pedal height in the Peugeot 307 locate the adjuster bolt on the floor under the clutch pedal. Loosen the bolt and pull out the pedal to the proper height then tighten the bolt. To make the clutch pedal lower for the operator simply push in on the clutch pedal while the adjuster bolt is loose, then tighten the bolt.
The clutch pedal usually squeaks where the clutch pedal is mounted under the dash. The clutch pedal pivots at its mounting point so it probaly just needs some lubed sprayed on it.
A 1995 Honda Accord clutch pedal switch is located directly under the clutch pedal. This switch stops the car from starting with depressing the clutch. This helps avoid accidents.
the clutch on a 2000 ford f250 is a hydraulic clutch there is no adjustment however check the bushing on the rod and pin on the clutch pedal this bushing wears out and you loose pedal if the pin is wrn ,you will have to replace the clutch pedal