answersLogoWhite

0

Not a good idea. Car will start in gear. Most likely you prblem is in the safety neutral and back up light switch that is easily replaced and located in the rear of the trans housing facing the firewall near the top[ of the trans. To replace unplug the wires and remove one bolt and bracket holding it in. Slide it straight out the trans.

User Avatar

Wiki User

15y ago

What else can I help you with?

Related Questions

How do you hook up a starter button in a 1980 Datsun 210?

I'm somewhat confused by your use of the term "starter button". I assume you're referring to hooking up a remote starter allowing you to spin the engine while you're working under the hood. First make sure that the vehicle is in either park or neutral. Second, make sure that the ignition switch is in the "off" position. Locate the starter solenoid which is atop the starter assembly. Disconnect the trigger wire at it's spade terminal. The wire will most likely be yellow in color. Connect one end of your remote starter button at this terminal on the starter and the other end to the positive battery post.


When did the starter button for a vehicel first appear?

The first electric starter with starter button appeared on a car called the Arnold in 1896.


Is it safe to keep pressing the starter button on an electric hot water heater to start it?

Starter button ? - you must have a very strange heater, they normally heat automatically when power is on, and I have fitted hundreds and NEVER seen a 'starter button'


Is there a common cause for a 1987 454 ltd not to crank when the start button in pressed?

Start by checking battery voltage and then use a test light to check for power at the starter when the button is pressed. If you have power at the starter with the button pressed it could be a bad starter. If no power at the starter then check into wiring and/or relays.


How do you change starter button on 1996 Honda magna?

changing starter button on 1996 honda magna 750 how to remove throdle cables from from hand grip.


How do you install a push button starter solenoid?

To install a push button starter solenoid, first disconnect the vehicle's battery to ensure safety. Locate the starter solenoid, usually mounted on or near the starter motor, and remove any necessary covers or panels. Connect the push button leads to the solenoid's positive terminal and the terminal leading to the starter, ensuring a secure connection. Finally, reassemble any removed components, reconnect the battery, and test the installation by pressing the button to start the engine.


How do you start Honda trx 250ex?

push the starter button


When the starter button is pushed on 2003 Honda Fourtrax 350 what causes it to click?

dead battery


How can I crop a button-up shirt without cutting it?

You can crop a button-up shirt without cutting it by tucking it into high-waisted pants or tying it at the waist to create a cropped look.


How do you get rid of black retranglar box on t.v. screen after hooking up convertor box?

Use the Captions (CC) button to de-select it.


What does the at button mean on a tracker?

Automatic Transmission


How do you get a puppy on the ville?

open ur market and next to the 'starter' button there is a button called 'pets' there u can buy them :)