0
You have a rover 400 the fan heater only works on no3 no 4 on the control switch but does not operate on the lower speeds why?
The resistor pack has burnt out
remove the glove box cover and you will see a wiring conector going into a black plate with 2 Phillips screws.
remove wiring and screws and remove resistor pack and replace
dealer price around �30
30 mins to change
VERY VERY COMMON PROBLEM
www.freewebs.com/hometek
ANSWER 2
Visit www.rezpax.com for the answer to all questions relating the subject of missing fan speeds.
Purchase replacement ceramic resistors
Download the Removal & Repair Guide
Send them your faulty Heater Resistor Pack for repair
All saving you many many £££'s
www.rezpax.com
What else can I help you with?
Where is heater relay switch on 2001 Ford Expedition?
Where is heater control switch
What are the symptoms of a bad heater control switch on a 1997 Oldsmobile Aurora?
It will not respond to all speeds... It will not change from high to low... It does nothing at all... It loose or smells burnt...
What would cause the AC or heater on a 1996 GMC Jimmy to not go on high?
fan speed control switch is bad. Replace it as long as the other speeds work fine.
How can you change heater control switch for a Hyundai?
Remove the heater control switch decorative cover. Remove the retaining screws. Remove the wiring harness. Reverse the process to install the new switch.
Where is the heater control relay in a 1992 Acura Vigor located at?
The 1992 Acura heater control relay switch can be found beneath the passenger side dashboard. The heater control relay switch will be a few inches above the kick plate.
Why is your fan heater control switch is permanently on full even though the switch is on off?
It could be the high speed heater motor relay is stuck on or the switch itself is broken.
How does a remote control operate a switch from a distance?
The remote control sends a radio signal to the base unit, and the base unit interprets the signal to switch the connected appliance on or off. Some remote control can operate multiple switches from a distance.
Can you operate a hunter fan with a dimmer switch?
No, it is not recommended to operate a Hunter fan with a dimmer switch. Fans require a specific type of control, such as a fan speed switch or a remote control. Using a dimmer switch can damage the fan's motor and may cause a fire hazard.
What does the heater control switch do?
It adjusts the heat in the car so you can control your AC and heat to the temperature you like.
How can I operate the fan and light control switch with a single device?
You can operate the fan and light control switch with a single device by using a combination switch that is designed to control both the fan and light functions. This type of switch allows you to adjust the settings for both the fan and light using one device, making it convenient and easy to use.
How do I turn on a Rheem water heater?
To turn on a Rheem water heater, locate the gas control valve or the power switch on the unit. For a gas water heater, turn the gas control valve to the "on" position. For an electric water heater, flip the power switch to the "on" position. Wait for the water heater to heat up before using hot water.
How do you replace Audi A3 heater control switch bulbs?
To replace the heater control switch bulbs in an Audi A3, first, disconnect the vehicle's battery to ensure safety. Remove the trim surrounding the heater control panel, typically using a trim removal tool. Once the panel is exposed, carefully detach the control switch assembly to access the bulbs. Replace the old bulbs with new ones, reassemble the switch and trim, and reconnect the battery to complete the process.
