answersLogoWhite

0

What else can I help you with?

Related Questions

Determine min frame size by collision detection interval?

The network doesn't need to see an entire frame before determining a collision has occured; as soon as it detects a transmission after or during the process of sending a frame there is a collision. Theoretically then it could be a part of a frame as small as a byte.


Does the transmission skid plate need to be removed to change the manual transmission fluid in a 1988 jeep wrangler?

No.


Where is the transmission located on a 1998 mystique Does the engine need to come out to change the transmission?

the transmission is located on the driver's side of the engine and yes the engine has to be removed to change the transmission


How many quarts of transmission fluid do you need for a 2000 ford f150?

That would depend on how much fluid was removed. Was it a typical fluid and filter replacement or was the transmission removed. If the tranny was not removed. always start with about 4 to 6 quarts. If the transmission has been removed and the torque converter drained, then about 8 to 10 quarts.


How do you remove 1998 Honda civic automatic transmission?

Removing the transmission on a 1998 Honda Civic takes time as it engine will need to be remove as well. The engine mounts will need to be removed, coolant drained, hoses removed and shift linkage removed. When everything is properly loosened, using an engine hoist, lift the motor out. Disconnect the transmission from the engine and replace the unit.


1984 Dodge A-413 transmission. Can the differential bearing be changed without pulling the transmission?

No. The access cover for the differential is only an inch or two forward of the K-frame/firewall in most applications. In order to replace the bearings, the differential carrier must be removed from the transmission; there is not enough clearance to do so with the transmission mounted to the engine, assuming you could even get the differential cover plate off. You will have to remove the transmission. The best way is to support the engine with a jack under the oil pan, unbolt the transmission, unbolt and mark the torque converter with respect to its position on the flywheel, and then lower the transmission out of the bottom of the car using an engine hoist. unless you drop the k frame, you will need to separate the lower ball joints, outer tie rod ends steering intermediate shaft and power steering hoses (if you only drop the frame down and don't completely remove it you wont need to touch the power steering hose) and the 4 bolts that hold the k frame to the unibody. anybody who has worked on a car before can probally do this. that should give lots of room to get at the diff.


Do you have to pull the motor to replace the transmission on a Chrysler pacifica?

No, but the suspension cradle may need removed.


How to change Smith Optics Goggle lens?

To change the lens on Smith Optics goggles, remove the frame from the lens by bending the frame slightly to release it. Once the frame is removed, insert the new lens by lining up the notches on the lens with the tabs on the frame, then snap the frame back in place. Make sure the lens is securely attached before using the goggles.


Can the transmission of a 2000 Oldsmobile intrigue be removed from the bottom of car without removing engine?

Yes ... You need to support the engine from above,there is a hanger that attaches to the top of the shock towers that has a hook on it that will support the engine, when you remove the engine cradle (frame) below.


How do you replace slave cylinder on 1998 Chevy S10 manual transmission I have been told I need to replace the entire transmission. Is this true?

The transmission must be removed, and put back in, not replaced.


Do you take out motor in Jeep Grand Cherokee to install transmisison?

No. The engine does not need removed to replace the transmission.


How do you change the auto transmission oil on a 2002 1.9tdi Passat?

The transmission fluid is not meant to ever need servicing unless the transmission pan has to be removed to repair the transmission. there are special tools involved that are a pain to use.