0
What else can I help you with?
Could throttle adjustment cause shifting problems?
no, check your fluid levels.
Your 1995 Cadillac Edorado is idleling very high What could possibly be the cause?
Could be the throttle plate is stuck - try to free with a screwdriver Could be the throttle plate is stuck - try to free with a screwdriver
What would cause lack of power and rattling during acceleration?
It depends on if you have a carburetor or fuel injection but it is probably in the throttle body. You could have trash in your throttle body or the throttle body is worn out.
What could cause no power to the fuel pump on a 2000 kia sportage?
fuel pump relay under hood in the fuse box
What would make a 2000 KIA Sportage spit and sputter on acceleration?
There could be a few causes for a car to spit and sputter on acceleration. One common cause would be the engine not getting enough fuel, so it could be a problem in the fuel line, fuel filter, or fuel pump.
What would cause the accelerator of a 1995 GMC sierra pickup to stick?
Could be a bad throttle body
97 galant is idling at 200 RPM what could cause that to happen?
The throttle position sensor (tps) could make the rpms vary.
What can cause acceleration on a Honda civic on its own while on drive?
check for throttle cable binding on the throttle body, if it jumps out of track it can often cause uncontrolled acceleration while in gear...if not that it could possibly be caused by a sensor beginning to go bad
What could cause the throttle to be stuck wide open after changing exhaust intake manifold gasket?
Throttle plate stuck - bound up Manifold tightened unevenly? Throttle plate stuck - bound up Manifold tightened unevenly? Control
What could cause a 1994 Buick LeSabre to stall when attempting to accelerate over 50mph?
the tps is bad-throttle positioning sensor
What could cause your gas pedal to shake and vibrate?
check the recalls for the 99 mercury cougar!! it includes a recall on the throttle cable...
What could cause low idle then speed up?
mostly the tps or throttle positioning sensor. it would be a good idea to change that
