0
To adjust the clutch cable on a Yamaha Raptor 660, first, locate the cable adjuster near the clutch lever. Loosen the lock nut and turn the adjuster to either increase or decrease tension; turning it clockwise tightens the cable, while counterclockwise loosens it. Ensure there is a slight gap between the lever and the perch when the clutch is pulled in. Finally, tighten the lock nut and test the clutch operation to confirm proper adjustment.
What else can I help you with?
How do you change the clutch on a 2002 Yamaha 660 raptor?
To change the clutch on a 2002 Yamaha 660 Raptor, start by removing the clutch cover bolts and taking off the cover. Disconnect the clutch cable from the lever and remove the pressure plate by unscrewing the bolts. Take out the old clutch plates and replace them with new ones, ensuring they are properly aligned. Reassemble by reversing the steps, making sure to adjust the clutch cable for proper tension.
How do you adjust a raptor 660 carb?
To adjust the carburetor on a Yamaha Raptor 660, start by ensuring the engine is warm. Then, locate the air/fuel mixture screw, typically found on the side of the carburetor, and turn it clockwise to lean the mixture or counterclockwise to enrich it. Adjust the idle speed using the idle screw, usually found near the throttle cable. Finally, test the throttle response and make minor adjustments as needed for optimal performance.
What is the horsepower of a raptor 660?
The Yamaha Raptor 660 stock has 43hp.
How many cylinders does a Raptor 660 have?
The Yamaha Raptor 660 is a single cylinder.
How fast is a 660 raptor?
my raptor 660 will top out at about 80MPH
Where can one view images of the 660 Raptor?
Raptor Forum has over 36 images of the 660 Raptor. The easiest method for finding the 660 Raptor is to use the box in the right hand corner of the site.
Who would win Honda 250 dirt bike or raptor 660?
raptor 660 win
Yamaha raptor 660 starter turns but dont start?
your one way starter clutch is blown out. same problem happened to me and raptors are highly know to break starter clutches. just buy an extreme raptor starter clutch kit.
What is the top speed of a 2003 660 raptor?
660
How do you install clutch on raptor 660?
To install a clutch on a Yamaha Raptor 660, first, remove the left side cover by unscrewing the bolts and taking off the cover. Next, remove the clutch springs and plates, then replace them with the new clutch components, ensuring they're properly aligned. Reassemble the side cover, torque the bolts to the manufacturer's specifications, and check the clutch lever adjustment before testing. Always refer to the service manual for specific instructions and torque values.
Where can one purchase Yamaha Raptor 660?
The Yamaha Raptor 660 is a motorcycle that was made by Yamaha between 2001 and 2006. One can purchase a second-hand Yamaha Raptor 660 at a used Yamaha dealer.
What is the first year the Yamaha raptor 660 was produced?
Yamaha sold the Raptor 660 from model year 2001 through 2005. They then redesigned the Raptor 660R in 2006 released it as a Raptor 700R.
