0
What else can I help you with?
How do you many clutch plates in a Yamaha blaster clutch?
there should be 6 clutch plates
How do you fit clutch cable?
How to fit clutch cable on a daewoo cielo
How do you install a clutch on a 2001 Honda 400ex?
Are you replacing a whole clutch or just the clutch plates?
Why does a clutch fail?
There is more than reason. A clutch has plates that engage and disengage. The plates can wear out , often mostly due to riding the clutch or other improper operation. The clutch also has bearing and springs- if any of these breaks, the clutch fails.
How do ya adjust a clutch pack on a 84 shadow VT700c?
The clutch is non-adjustable. It uses hydraulic fluid to release the clutch. If you are experiencing a dragging clutch, check your plates for warpage. This bike uses a 'slipper' type clutch so having the correct plates in certain places is important. If you have not changed your plates and they are the originals, check that the clutch fluid doesnt have air in it.
How do you install a clutch on a 2003 Honda cbr600?
To replace the clutch plates, drain the oil, and the right side engine cover has to come off. Then, remove the clutch bolts in a criss-cross pattern, slowly releasing the pressure on the clutch plates. Usually just the fibre plates are replaced, the metal ones may be ok. Buy a clutch rebuild kit with new springs, plates, and cover gasket.
What would cause your rm125 dirt bikes clutch not engage?
bad clutch cable, or not enough oil on the clutch plates.
How do you determine when to replace clutch plate in a bike?
If the clutch is operating normally, there is no need to replace clutch plates. If the clutch is slipping and cable or hydraulic operating method is working correctly, oil is of the correct grade and in good order & clutch springs are within manufacturers tolerances, the probable cause would be worn clutch plates. Measure both friction plates and steel plates to determine whether just friction plates can be replaced & dont forget to soak new friction plates in oil before fitting. Unless you know what you are doing and have the corect tools, I would suggest it is a job for a motorcycle dealer (such as ourselves - www.aprilia-merseyside.com)
What is clutch drag?
Source http://www.nightrider.com/biketech/hdclutch.htm Q: What causes my clutch to stick or drag? A: There is no single cause of a sticking clutch. Some more common reasons for a sticking clutch are:- Clutch controls are improperly adjusted. Clutch cable is collapsing.- Clutch spring tension is to tight, spring binding.- Too heavy an oil has been used in the clutch. A thick viscosity oil can cause the plates to stick, especially when cold.- Clutch oil is 'worn out' or burnt. The oil has been in the clutch to long, clutch plate wear is excessive causing slippage, or a driving style that slips the clutch. Changing the oil in a clutch often improves the situation.- Clutch plates are warped. Friction plates or metal plates may be warped.- Improper adjustment on primary drive chain/belt.Hope This Helps.
Fit corsa clutch master cylinder?
consentric clutch type
Why does my Honda trx 450r run like the clutch is engaged when it's not?
Sounds like clutch slip. Either the clutch springs need adjusting or the clutch plates are worn out.
Why doesnt Clutch disengage when pedal is depressed on my 1970 VW bettle?
Clutch plates are sticking - get your clutch checked you might need a new one
