0
What else can I help you with?
How do you adjust the clutch on a 1993 Tercel?
there is not adjustment for the clutch, you need to replace it if is bad.
Why is Geo storm shifting into gears but slips?
You probobly need to replace the clutch.
1997 ultra classic wont move until clutch lever is let out all the way?
need a clutch cable adjustment. it is likely that it is too tight
Where is the clutch fluid in a 96 Nissan 200sx?
The '96 200sx has no fluid for the clutch. This car has a cable operated clutch that needs to be adjusted. If the cable breaks the clutch will not disengage. If the clutch is getting tight it will need lubed. If lubing the cable doesn't work a new cable is needed.
How do you fit a new clutch to a vauxhall zaferia?
first undo all the nuts that hold the clutch housing, then remove it. next undo all the bolts holding the clutch in place, remove clutch and put new one in place, replace bolts & tighten them very tight. next screw on the clutch housing (the nuts don't need to be as tight). Easy really, piece of cake in fact
How do you remove fan from 1993 ford econoline e150 4.9liter 6 cylinder?
You need to rent or buy a fan clutch removal tool kit. you need to remove the fan and clutch as one before you can separate the fan from the clutch.
How do you adjust the clutch on 1993 Mazda MX6?
YOu need to blead the system .. then it should require no adjusting
What parts are needed to repace the clutch on a 323 1993 Mazda?
To replace the clutch on a 1993 Mazda 323, you will need a new clutch kit, which typically includes a clutch disc, pressure plate, and release bearing. Additionally, you may need a new pilot bearing, clutch alignment tool, and transmission fluid. It’s also advisable to have a flywheel resurfaced or replaced if it shows signs of wear. Ensure you have the necessary tools for disassembly and reassembly, including a socket set and torque wrench.
1993 Yamaha 250 timberwolf starter clutch removal?
You need to first pull the flywheel/magneto off of the crank shaft. The starter clutch is attached to the back side of it with bolts.
How do you remove clutch fan from 1993 explorer?
to remove a clutch fan on a ford, you need special tools . also fan thread is left hand thread ,so you unscrew it clockwise
Where do you check the clutch fluid and how do you know if your clutch went out on a 1993 Nissan truck?
look at your clutch master cylinder and check fluid, if low ,check your slave cylinder for leaks ,its bolted on your transmission with 2 bolts ,its at where the boot is ,if leaking ,then replace ,if not then u will need anew clutch.
How do you change clutch on 1993 mercury capri?
http://www.techcapri.com/Repair/Capri_Service_Manual.htmthis link will give you all of the information you will need
